Using The Cd Player; To Load Cds; To Unload Cds - JVC MX-KA3 Instructions Manual

Example of indication:
When CD tray has eiected once and then
CD1 is pressed (DISC1 is selected)
Shows that this disc number is selected
Shows that the disc is rotating
One Touch Play
'Ihe power comes on, and operations are done automa/ically.
i_ By pressing the CO !b/ll button, the System will come on, and if
a CD is loaded for the disc number that was lastly selected, it
will start playing fiom the first track.
i_ By pressing the CD1 -CD3 button, the System will come on, and
if a CD is ah-eady loaded for the selected disc number, it will
start play fiom the first track.
To Load CDs
1
Press the CD Open/Close • button on the
Unit to open the tray.
2 Place a CD, with its label side up, onto the
tray.
Be sure that the CD is securely seated on the disc tray.
With the Eabel side up
Using the CD Player
t_lWhen you use an 8 cm (3") CD, place it on the inner circle of the
tray.
t_lYou can load CDs while listening to the other source or while
listening to the CD being played back.
t_lWhen power is turned off with the tray opened, the tray is auto-
matically closed.
t_lIf the CD cannot be read correctly (because it is scralched, for
example), "0 0:00" appears on the display.
To Unload CDs
Take out the CD as shown below.
1
While the CD Player is stopped, press the CD
Open/Close A button on the Unit to open the
tray.
2 Remove the CD, then press the DISC SKIP
button on the Unit.
'Ihe tray turns for the next CD.
3 Repeat step 2 to remove all the CDs.
4
Press the CD Open/Close A_Abutton on the
Unit to close the tray.
I_1You can remove CDs while listening to the other source.
• You can also remove the CDs duringplayback, However,
in tills case, you can only remove the CDs that are not be
ing played back.
3 Press the DISC SKIP button on the Unit and
place the next CD.
When you press the button, the tray turns for the next CD.
4 Repeat step 3 for the last CD.
5 Press the CD Open/Close A_A button on the
Unit.
The tray is closed,
• When placing a disc in tile tray, be sure to position the
disc inside the recess correctly. Otherwise, tile message
"NO DISC" will appear in tile display, and tile disc may be
damaged or tile unit may be damaged when tile tray is
opened, or it may be difficult to remove tile disc from tile
uniL