Camera Alerts; Manual Entry - Whistler RLC-100 Owner's Manual

OPERATION
The following steps outline the options available
for select features.
1) Press Menu (M) until a feature is displayed.
2) Press Enter (E) to show one option.
3) Press M to view all options.
4) Press E to save the option shown.
Press M until To change Options Press M
unit shows: setting: to enter selection:
BRT Press E ON, OFF
Press E
SPD SP 1, SP 2
LSPD Press E L80, L90, L100,
OFF , L30, L40
L50, L60, L70
Press E -08, -07, -06 etc
LOCA
Press E
ALAR ON, OFF
REST Press E ON, OFF
Press E
RADI 600, 400, 200
TEST Press E ON, OFF
NOTE:
BRT = Select display brightness
SPD = SP 1= MPH/Yards, SP 2 = KPH/Meters
LSPD = Select the speed that the unit will alarm
LOCA = Select the correct time- correction for your
area
14
OPERATION
ALAR = Select the "Top of the Hour" alert
REST = Select stay alert
RADI = Selects alarm distance
TEST = Turns off greeting voice

Camera Alerts

When a camera location is approached, the
unit will announce the type of alert (Red Light
Camera, Traffic Camera, Speed Camera, or
User Selected), for example, "Warning, traffic
camera ahead" and the display counts down
the distance to the camera.
Two alert LEDs on either side of the display will
flash faster as you get closer to the camera.
Once past the camera location, the unit will
provide an "all clear" beep-beep type audio
tone.
IMPORTANT: The RLC-100 is a red light/speed
camera locator and does not detect laser or
radar signals.
15
OPERATION

Manual Entry

The RLC-100 will save a special location (i.e., a
new red light camera or even a "trap") if you
enter it manually. The unit will store 100 user
locations. NOTE: Manual entries must be
approximately 100 yards apart to prevent
overlapping locations.
To manually enter a location, simply press
Enter (E) and the unit will announce "user
point logged".
Press the Enter (E)
button to save a
new location.
When detecting this position, the unit will
announce "warning user position ahead" the
next time it approaches this location..
To delete manual locations:
When the unit is alerting a manual location,
press Enter (E) and unit will announce "user
position deleted".
16