Automatic Transmission Fluid - Honda Pilot Owner's Manual

Main Menu

Automatic Transmission Fluid

Automatic Transmission
DIPSTICK
Check the fluid level with the engine
at normal operating temperature.
1.
Park the vehicle on level ground.
Start the engine, let it run until the
radiator fan comes on, then shut
off the engine. For accurate
results, wait about 60 seconds (but
no longer than 90 seconds) before
doing step 2.
250
Table Of Contents
2. Remove the dipstick (yellow loop)
from the transmission, and wipe it
with a clean cloth.
3. Insert the dipstick all the way into
the transmission securely as
shown in the illustration.
4. Remove the dipstick and check
the fluid level. It should be
between the upper and lower
marks.
DIPSTICK
UPPER MARK
LOWER MARK
2008 Pilot
5. If the level is below the lower
mark, remove the fill plug, then
add the fluid into the fill hole to
bring it to the level between the
upper and lower marks on the
dipstick.
Pour the fluid slowly and carefully
so you do not spill any. Clean up
any spill immediately; it could
damage components in the engine
compartment.
Always use Honda ATF-Z1
(automatic transmission fluid).