Advertisement
When the camera is ready to measure white
balance, a flashing
P,-E (PRE)will appear in
the viewfinder
and information
display.
5
6
Measure
white
balance.
Before the indicators stop flashing, frame the
reference object so that it fills the viewfinder
and press the shutter-release
button all the
way down.
No photograph
will be recorded; white balance can be measured
accurately
even when the camera is not in focus.
Check the results.
If the camera was able to measure a value for
white balance, the message shown at right
ud
in
will be displayed and '-
will flash
the
viewfinder
for about eight seconds before
the camera returns to shooting
mode. To
return to shooting
mode immediately,
press
the shutter-release
button halfway.
If lighting
is too dark or too bright, the
camera may be unable to measure white
balance.
A message will appear in the
l-
information
display and a flashing no
ud
will appear in the viewfinder.
Press the
shutter-release
button halfway to return to
Step 4 and measure white balance again.
\\
//
//
/\
1O0
Advertisement
