Table of Contents
Advertisement
Answering Calls
the ring tone through the
have Caller Number Identification (Caller ID) service
from your service provider, the caller's phone number is
shown in the display.
Answer the phone by pressing
replaced by the call timer display. End the call by press-
ing
.
NO
Call Waiting
If you have call waiting service from your service pro-
vider, press
YES
waiting signal. You can switch between the two calls by
pressing
YES
both calls.
Unanswered Calls
Your phone's display shows the number of calls you have
received but did not answer. You can clear the number of
missed calls from the display by pressing any key except
. If Caller Number Identification is available from
YES
your carrier, unanswered calls will be stored in the
Basic Operations
When your phone receives a call,
the ring tone sounds, Incoming
Call appears in the display, and
the display and keypad backlight
are illuminated. (you can disable
menu). If you
. Incoming Call is
YES
to answer a call when you receive the call
.
press
until you are ready to end
NO
of the
menu. Press
Temporarily Muting the Ring Tone
Caller Number Identification
Muting the Microphone During a Call
Increasing or Decreasing Ear Volume During a Call
YES
from the Missed Calls Indicator screen to access the
Incoming Call Log.
To temporarily mute the ring tone without answering
the call, press
or the upper or lower side volume key
NO
Incoming Call is still shown in the display, and you
can still answer the call by pressing
If your service provider has Caller Number Identifica-
tion (Caller ID) service, your phone shows the phone
number of an incoming call in the display. If the number
is one that you have stored in your phonebook with a
name, the name is shown when your phone rings. If the
Caller ID information is not available, the message NO
ID is shown in the display. The word Anonymous may
be shown if the Caller ID is restricted by the service pro-
vider or by the caller.
To mute the microphone during a call, press and hold
the
key. Mic Muted appears in the display when
CLR
the call is muted. Repeat this procedure to return to your
call.
Use the following instructions to increase or decrease ear
volume during a call:
.
.
YES
17
Advertisement
Table of Contents
