Answering Calls - Ericsson A1228D User Manual

Dual band, tri mode for tdma systems
Hide thumbs Also See for A1228D:
Table of Contents

Advertisement

A stop causes the phone to stop transmitting numbers
until you press
digits by pressing and holding
display. A pause temporarily suspends transmitting
numbers for approximately two seconds before sending
the next series. You can enter a pause in a series of digits
by pressing and holding
play.
For example, if your office has a voice mail system that
requires you to dial a phone number, followed by your
extension, followed by an access code, you could enter
the following: 555-1111
When you press
then stops transmitting tones. When your voice mail
system asks for your extension you would press
transmit your extension. The access code is sent after the
pause. If the timing in your voice mail system does not
allow for pauses, you can enter a stop instead of the
pause, or use multiple pauses.
You can also store groups of numbers which can include
stops and pauses in a phonebook location. You can then
dial the numbers by entering the phonebook location
and pressing
16
. You can enter a stop in a series of
YES
until
is shown in the
#
until
is shown in the dis-
*
2222
33333.
, your phone dials the number and
YES
.
YES

Answering Calls

to
YES
Call Waiting
Unanswered Calls
When your phone receives a call,
the ring tone sounds (unless you
have disabled it through the
menu). The words
TPVI9T
Incoming Call flash in the dis-
play, the display and keypad back light flash. If you have
Caller Number Identification (Caller ID) service from
your service provider, the caller's phone number is
shown in the display.
Answer the phone by pressing
Call is replaced by the call timer display.
End the call by pressing
.
NO
If you have call waiting service from your service pro-
vider, press
to answer a call when you receive the call
YES
waiting signal. You can switch between the two calls by
pressing
.
press
until you are ready to end
YES
9‚Á‚‡
NO
both calls.
Your phone's display shows the number of calls you have
received but did not answer. You can clear the number
from the display by pressing any key. If Caller Number
Identification is available from your carrier, unanswered
calls will be stored in the
Dp‚€vtÃG‚t
menu.
QCPI@ÃGDTUT
. Incoming
YES
of the
Basic Operations

Advertisement

Table of Contents
loading

Table of Contents