Removing The Battery; Turning On And Off The Camera - Nikon COOLPIX P7000 User Manual

Removing the Battery
Before opening the battery-chamber/memory card slot
cover, turn the camera off (_19) and confirm that the
power-on
lamp
and the monitor are off.
To
eject the battery,
open the
battery-chamber/memory
card slot cover and slide the
battery
latch in the direction
shown (_). Then, remove the battery straight ((2}).
Note that the battery or memory card may become hot during use; observe due
caution when removing the battery.
Turning On and Off the Camera
Press the power switch.
The power-on lamp (green) and the
monitor are turned on (when the
monitor is turned on, the power-on lamp
turns off).
Press the power switch again to turn off
the camera. When the power is turned
off,
the power-on
lamp
and monitor also turn off.
• When the camera is
off, holding
down the
[]
button turns on the camera in
playback mode (_30).
@
[] Standby Mode (Auto Off)
If no operations are per_rmed, the monitor is turned off automatically, the camera enters standby
mode and the power on lamp blinks. The camera turns off when the standby mode continues for
about three minutes.
• When the power on lamp blin ks, turn on the monitor again with one of the following operations.
Press the power switch, the shutter release button or the [] button.
Rotate the mode dial.
• During shooting or playback, if no operations are performed for about a minute (default setting),
the camera enters standby mode.
• The time that elapses before the camera enters standby mode can be changed from the Auto off
(_181) in the setup menu (_167).
19