Specifications - Panasonic Omnivision VHS PV-VS4820 Operating Instructions Manual

Playing olderor
damaged tapes may eventually
cause video heads to become clogged.
Video Head Clog Sensor
During playback this
screen appears if
clogging is detected.
To remove screen,
press PLAY on the
remote or VCR.
VIDEO HEADS MAY
NEED CLEANING
PLEASE iNSERT HEAD
CLEANING CASSETTE
OR R_F_R TO MANUAL
END PLAY K_Y
............................... )
• Use "dry" type head cleaning cassette only.
(Part No. NV-TCL30PT is recommended.)
I Cteaning Tape I_
• Follow cleaning tape instructions carefully.
Excessive use of tape can shorten head life.
• If head clog symptoms persist, contact your
nearest Factory Service Center or authorized
Service Center. (See page 48.)
Power Source:
Power Consumption:
Video Signal:
V'Bdeo Recording System:
Audio Track:
Tuner:
Broadcast Channels:
CABLE Channels:
120 V AC, 60 Hz
Pow__On Approx. 28 watts
Pow_ Approx. 3.7 watts
EIA Standard NTSC color
4 rotary heads helical
scanning system
1 track (Normal)
2 channel (Hi-Fi Audio Sound)
"VHF 2-13, UHF 14-69
Midband A through I (14-22)
Superband J through W (23-36)
Hyperband AA-EEE (37~64)
Lowband A-5-A÷I (95-99)
Special CABLE channel 5 A (01)
Ultraband 65-94, 100-125
S-VlDEOlnput/OutputLevel: S-VIDEO CONNECTOR
(SEPARATED YC CONNECTOE):
Y CONNECTOR 1.0
Vp-p.
75 ohm unbalanced
C CONNECTOR 0.286 Vp-p
75 ohm unbalanced
Operating Temperature: 5 °C-40 °C (41 °F-104 °F)
Operating Humidity: 10 %-75 %
Weight: 3.5 kg (7.7 Ibs.)
Dimensions: 430 (W) x 98 (H) x 250 (D) mm
16-15/16" (W) x 3-7/8" (H) x
9-3/4" (D)
Note: Designs and specifications are subject to change without notice.
A clean video head helps produce a clear
picture.
So, we have equipped your VCR with a built-
in, non-chemical head cleaning system that
helps prevent clogging of the video heads.
Cleaning is performed each time you load or
unload a video cassette.
• This feature is preventative only, If your video
heads are seriously clogged, consider the use
of a chemical non-abrasive head cleaning kit or
take your VCR to a Service Center.
Use a soft cloth or dusting attachment of
your vacuum cleaner to dust your VCR.
Remove dust from the ventilation holes on
the back sides and bottom of the cabinet.
Plastic surfaces are easily scratched and
can be marred by alcohol and various
solvents. Avoid excessive use of oil-based
furniture polishes since the materials used
in the cabinet will accumulate more dust.
We recommend using a nonabrasive,
antistatic cleaner and polisher.
Diqital Auto Picture
Automatically controls the video output signal for
less noise depending on the tape condition.
DiQital Auto Tracking
Continuously analyzes the signal and adjusts for
optimum picture quality.
Manual Trackino Control (to reduce_picture noise)
Use during Playback and Slow Motion mode to reduce
picture noise. Press CH (TRACKING) • / • buttons on
the remote control or on the VCR until the picture clears
up, To return to Auto Tracking, press POWER off, then on
again a few seconds later.
V-Lock Control (to reduce picture jitter)
In Still mode, CH (TRACKING) • / • buttons operate as a
V-Lock control.
CNR (Color Noise Reduction)/ANR (Advanced
Noise Reduction)
Color Noise Reduction reduces the color noise.
Advanced Noise Reduction reduces the luminance noise.
45