Recording - Panasonic Omnivision VHS PV-VS4820 Operating Instructions Manual

Connections you'll need to make.
Playing (Source) VCR
Recording (Editing) VCR TV for Monitoring
i ii i
AUDI -VIDEO IN FROM ANT.
MONO _ i
O L O S-VIDEO VHF/UHF
AUDIO S-VIDEO IN FROM ANT.
MONO -]L U
_'_ L OI_S-V]DEO VHF/UHF
VIDEO i OUTTOTV
©
_INI OUT
or
Front of VCR VIDE01N20 [Jf/£_-AU010[N2-Ro 0
AUDIO IN
VHF/ 0
IJ-F VIOEOIN
o
2
Insert blank tape
with record tab.
Select LINE mode.
Press INPUT.
(See "Selecting the
Input Mode" below.)
Put in Standby mode.
Press PLAY, then
PAUSE/SLOW at starting
point.
REC
PAUSE I
and C_E)
SLOW
Put in Standby mode.
Press REC, then
PAUSE/SLOW
immediately.
4
5
Ii Start dubbing. _ Start d!bbing.
Press PLAY. SLOW I Press P USE/SLOW.
Stop dubbing. _ Stop dubbing.
Press STOP. _ Press STOP,
• To Monitor Dubbing on Your TV
1 Turn your "IV on and tune to the Recording
VCR channel (CH3 or CH4).
2
Set the VCR/"IV Selector on the Recording
VCR to "VCR."
I Dubbing tapes protected with Copy Guard will have
poor quality results.
• Selecting the Input Mode
Method1: Press INPUT.
Channel Number <--> LINE1 <--> LINE2
Method2: Press CH A/Y. Display will change as below.
• "LI" or "L2" lights on Multi-Function Display
(about 4 sec.) when LINE1 or LINE2 is selected.
• LINE1: For rear audio/video connection.
LINE2.: For front audio_ideo connection.
3aution:
unauthorized exchanging and/or copying of copyrighted recordings may be copyright Infringement.)
]5