Dst (Daylight Saving Time) - Panasonic Omnivision VHS PV-VS4820 Operating Instructions Manual

Use when moving VCR to new location, or if a mistake
was made in the One Time VCR Setup section.
• Make sure a tape is not inserted in the VCR,
Break off the tab.
Record Tab
1 Turn VCR
Power on.
Press and hold both PLAY
and CHANNEL • on the VCR
for more than 5 seconds.
• The power will shut off.
3
Do "one Time VCR Setup" steps on page 8.
lb
Screw driver
To record again
Cover the hole
with cellophane tape.
VCR auto adjusts clock for DST. (Page 11 .)
Spring (First Sunday in April)
DST:ON --> sets clock ahead one hour.
Autumn (Last Sunday in October)
DST:ON --> Turns clock back one hour.
• If your area does not observe Daylight Saving
Time, select DST:OFF.
• Keep these time changes in mind when
programming the VCR for timer recordings.
Trade Name:
Responsibility Party:
Address:
Telephone Number:
Panasonic
Matsushita Electric
Corporation of America
One Panasonic Way
Secaucus New Jersey
07094
t-800-211-PANA (7262)
Only use tapes with the _ or _ mark in this unit.
Type of Video Cassette
Tape Speed
Setting T60 T120 T160
SP 2 Hours
(Standard Play) 1 Hour 2 Hours 40 Minutes
LP 5 Hours
(Long Play) 2 Hours 4 Hours 20 Minutes
SLP
(Super Long Play) 3 Hours 6 Hours 8 Hours
• LP recording is not possible in S-VHS/S-VHS ET mode.
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undersired operation.