Connecting A Digital/Satellite Receiver Or Decoder; Connecting An Amplifier Or System Component - Panasonic Diga DMR-EH50 Operating Instructions Manual

•Decoder here means the device used t odecode scrambled broadcasts (Pay T V).
oChange the "AV2 I nput" and "AV2 Connection" settings inthe SETUP menu tomatch the connected equipment (-_ 57) a fter tuning i s
completed (-_ 18, 1 9).
Digital receiver,
satellite receiver or
decoder's rear panel
21-pin Scart cable --
Viewing video from the decoder on the television while the
unit is stopped or while recording.
If you connected the television to the AVl terminal and the decoder
to the AV2 terminal on this unit, press [0]÷[ENTER]. ("DVD"
appears on the unit's display.)
Press again to cancel. ("TV" appears on the unit's display.)
olf the television is compatible with RGB input, the RGB output
signal from the decoder can also be output from the main unit the
same way.
This unit's rear panel
• To enjoy multi-channel surround sound on
DVD-Video
Connect an amplifier with Dolby Digital, DTS and MPEG decoders
using an optical digital audio cable and change the settings in
"Digital Audio Output" (-_ 56) after tuning is completed (-_ 18, 19).
oBefore purchasing an optical digital audio cable (not included),
check the terminal shape of the connected equipment.
oYou cannot use DTS Digital Surround decoders not suited to
DVD.
• Even if using this connection, output will be only 2 channels when
playing DVD-Audio.
Amplifier's rear panel
• Connection to a stereo amplifier
Amplifier's rear panel
Optical digital
cable
Do not bend sharply Insert fully, with this
when connecting, side facing up.
Red White
This unit's rear panel
This unit's rear panel