Table of Contents
Advertisement
Installation
Television
Location
This unit can be used as part of an entertainment center. Consult
your dealer for available
options.
Avoid
excessive
sunlight
or bright
lights,
including
reflections.
Keep away from excessive heat or moisture. _nadequate
ventilation may cause internal component failure.
Fluorescent
lighting
may
reduce
remote
centre]
transmitting range.
Keep away from magnetic equipment,
including motors,
fans and external speakers.
Optional
Cable Connections
Shielded
audio
and video
cables
should
be used between
components.
For best results:
Use 75-ohm coaxial shielded cables.
Use appropriate input and output connectors, that match
your component connectors.
Avoid long cables to minimize interference.
AC Power
Supply
Cord
CAUTION:
TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO W_DE SLOT
OF AC OUTLET AND FULLY INSERT DO NOT
_olarizedplug
USE A PLUG W_TH A RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED
OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,
CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT
FROM THE APPARATUS.
Cable / Antenna
Connection
For proper
reception,
either a cable or antenna
connection
is required.
Cable Connection
rncom_ng Cablefrom
Cable Company
Connect the cable supplied by your local
cablecempany
to ANTi
connection
on
_.
back of television. Select ANT1 and Cable
mode in SET UP menu.
Note:
A cable
converter
box may be
75OhnIVHF/UHF
On baCJ_ Of IV
required
for
proper
reception.
Check
with
your
local
cable
company for compatibility requirements.
Antenna
Connection
For proper reception of VHF/UHF channels, an external antenna
is
required.
For
best
reception
an
outdoor
antenna
is
recommended.
Connect home antenna
to ANT1 enc0mingCablefr0m
connection
on back of television.
HomeAntenna
Select ANT1 and TV mode in the
SET UP menu.
:
Note:
Cable
Mode
is
preset
at
the
factor_
Antenna
users
must
change to TV Mode and ANT 1 it)
the Set Up menu.
/NS TALLA T/ON
Remote Control
Battery
Installation
Requires two AA batteries
(supplied).
Procedure
1. Turn the remote control face down. Remove battery
cover by pressing down on the marking on the cover
and sliding it off in the direction indicated.
2.
Install batteries matching (+) and (-) polarity signs.
3.
Replace the battery cover by sliding in reverse until the
lock snaps.
Note:
Incorrect installation cat) cause battery leakage and
corrosion that will damage the Remote Control
Precautions
Replace batteries in pairs.
Do not mix battery types (zinc carbon with alkaline).
Do not recharge, heat, short-circuit, disassemble, or
bum batteries.
50
Advertisement
Table of Contents
