Table of Contents
Advertisement
SET UP (cont.)
g
CONVERGE
(cont.)
Note:
After selecting, press VOL I_ to activate
RESET TO
DEFAULT
feature.
When using this feature in Zoom
mode, the effect cat} only be verified whet} you exit all
menus and display normal picture.
m
CONVERGENCEADJ.
Procedure
A_er pressing VOL I_ the align Green to Center screen
will be displayed.
Then use the navigation buttons on the remote control
to align the horizontal and vertical green lines on screen,
with the cabinet reference marks on top center and left
center of cabinet, as shown below.
Reference
Marks
PRESS CH ANZ} VOL KEY TO
ALIGN GREEi'4 LINES TO TNE
A
GENTNR MARK ON THE G_gtNET
LEF_ _
_ F_IGNT
Front
o[ca_3irlet
_
PRESSAGTIONTOCONTI_4UN
ACTION
Press
0
to display
red center
correction
screen.
Use the navigation buttons on the remote control to align
the red cross with the white cross pattern at the center of
the screen.
Note:
Note:
To prevent picture tube damage, do not leave
test pattern on for an extended period of time.
Then press "0" on the remote control keypad to display
the BLUE center correction screen, repeat procedure for
adjusting
blue. If needed press "0" again to return to
RED correction screen.
At} adjusted cross pattern appears white with a minimum
of color protrusion.
Press
/CON MENUS OPERAT/ON
NINE POINT CONVERGENCE
CORRECTION
Note:
Remote Control must be in 73/mode.
Procedure
ACTION
Press
O
to display red correction screen.
Press the 1 through 9 keypad buttons on the remote
control to select the desired convergence position.
Use the navigation
buttons to align the RED cross with
the white cross pattern.
Note:
At} adjusted cross pattern appears white with a minimum
of color protrusion.
Press "0" on the remote control keypad to display the
BLUE correction screen, then repeat procedure.
ACTION
To exit press
_
repeatedly, then press CH A
g
OTHER
ADJ.
Highlight
OTHER
ADJ. and press VOL i_ to enter sub sub-
menu field.
Note:
While sub sub-menu features are highlighted, press
VOL I_ to adjust or activate.
MODE
- To select
TV (antenna)
or CABLE
mode
depending on the signal source.
AUTO
PROGRAM
- To automatically
program
all
channels received through the RF input.
MANUAL
PROGRAM
- To manually
add
or delete
channels.
AUTO POWER ON - Select SET to power up the TV at
the same time as the Cable box or other components
or
select OFE
CHAN BANNER - Select ON to display onscreen banner
when changing channels.
iMAGE SHIFT - Selecting ON is recommended
for this
feature to prevent image retention on screen.
29 •
Advertisement
Table of Contents
