Advertisement
To
PLAYBACK
2
Be sure the PREPARATIONS
on page 1 have been completed before proceeding to step 1 below,
AT THE "IV
1
Turn the "rv ON and
/
select its VCR
channel.
The TV's VCR Channel is
either channel 3 or 4.
AT THE VCR
Insert a cassette.
The Power will come ON
automatically.
If the Record Tab (page 16) is
removed, playback will start
automatically, (In this case
skip step 3.)
l lf a cassette is already in the
'VCR, just press the POWER
Button ON.
START PLAYBACK
Press the PLAY
Button.
The VCR Indicator will light.
This automatically sets the
VCR mode (see below).
For Special Effectssee
page 9.
STOP pLAYBACK
_L
Press the STOP
-.lr
Button.
• Pressthe EJECT Button to
remove the cassette.
1
POWER ON;
SELECT THE
VCR CHANNEL
CASSETTE
VCR INDICATOR
"VCR"
4 STOP/EJECT 4
BuI-rON
USING
THE
VCR/TV
SELECTOR
BuTroN
After you have a cable system or antenna connected to your VCR and the "TO GET STARTED"
connections
on page 1 are
complete, you can begin to watch TV broadcast
channels using your VCR or TV tuner.
ANTENNA
(or CABLE)
T
Remote Control
VCR/t'V Selector
TV
VCR Indl
"VCR"
TO SELECT
CHANNELS
AT THE VCR FOR VIEWING
OR RECORDING
g is necessary to place the VCR in the "VCR" mode, Be sure that the TV is tuned to the same channel which was selected
for the VCR channel (CH3 or 4) above.
1) WHEN YOU TURN ON YOUR VCR
The "VCR" mode is automatically selected, just turn the TV power ON and select the VCR CHANNEL,
2) WHEN THE VCR POWER
IS ALREADY ON
The VCR indicator should show on the front panel.
If the VCR Indicator is not showing, select the "VCR" mode by pressing the VCR/TV SELECTOR
Button once,
Select channels using the VCR REMOTE
CONTROL
CHANNEL UP/DOWN
Keys or the NUMERIC
Keys.
TO SELECT
CHANNELS
AT THE TVFOR
VIEWING
In "TV" mode no "VCR" indicator shows on the front panel.
1) WHEN THE VCR iS TURNED
OFF
The "TV" mode is automatically
selected, just turn the TV power ON.
2) WHEN
THE VCR I?OWER iS ALREADY
ON
If the VCR Indicator is showing and the TV is already ON select the "TV" mode by pressing the VCR/TV SELECTOR
Button once. The VCR Indicator should NOT show on the front panel.
Select channels using the TV channel controls.
Advertisement
