Craftsman WEEDWACKER 358.791510 Instruction Manual page 10

when u sing m edium (red) or
(_) large ( black) line
when using lines with diameter
(_ smaller than medium (red) line
(optional)
Line glide Arrow
J
NOTE: Line glide plate must be rein-
stalled in cutting head before inserting
new line.
4. Insert both ends of your line
through the proper holes in the
side of the cutting head.
!
Positioning
Tunnel
CARBURETOR ADJUSTMENT
_J!_WARNING: Keep others away
when makingidle speed adjustments.
The trimmerhead will be spinning dur-
ing most of this procedure. Wear your
protective equipment and observe all
safety precautions. After making ad-
justments, the trimmer head must not
move or spin at idle speed.
The carburetor has been carefully set
at the factory. Adjustments may be
necessary if you notice any of the fol-
lowing conditions:
• Engine will not idle when the throttle is
released.
• The trimmer head moves or spins at
idle.
Make adjustments with the unit sup-
ported so the cutting attachment is off
the ground and will not make contact
with any object. Hold the unit by hand
while running and making adjust-
ments. Keep all parts of your body
away from the cutting attachment and
muffler.
Idle Speed Adjustment
Allow engine to idle. Adjust speed until
engine runs without trimmer head
moving or spinning (idle too fast) or
engine stalling (idle speed too slow).
• Turn idle speed screw clockwise to
increase engine speed if engine
stalls or dies.
• Turn idle speed screw counterclock-
wise to decrease engine speed if
trimmer head moves or spins at idle.
5. Pull the line and make sure the Iine
is against the hub and extended full
through the positioning tunnels.
Une against
the hub
Tunnel \
6. Correctly installed line will be the
same length on both ends.
Air Filter
Cover "_
Screw
&WARNING: Recheck the idle
speed after each adjustment. The
trimmer head must not move or spin at
idle speed to avoid serious injury to
the operator or others.
If you require further assistance or are
unsure about performing this proce-
dure, contact your Sears Service Cen-
ter or call our customer assistance
help line at 1-800-235-5878.
10