Advertisement
$ERVUCE AND ADJUSTMENTS
CAUTION:
o
o
o
0
o
o
BEFORE PERFORMING
ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake
pedal fully and set parking brake.
Place gearshift lever in neutral (N) position.
Place attachment clutch in "DISENGAGED"
position.
Turn ignition key "OFF" and remove key.
Make sure the blades and all moving parts have completely stopped,
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug,
TRACTOR
TO REMOVE
MOWER
(See Fig. 18)
Mower will be easier to remove from the right side of tractor°
=
Place attachment clutch in "DISENGAGED"
position,
•
Move attachment lift lever forward to lower mower to its
lowest position,
.
Roll belt off engine pulley_
o
Disconnect clutch rod from clutch lever by removing
retainer spring,
o
Disconnect
anti-sway
bar from chassis bracket by
removing retainer spring
o
Disconnect suspension arms from rear deck brackets
by removing retainer springs.,
•
Disconnect front links from deck by removing retainer
springs.,
o
Raise lift lever to raise suspension arms, Slide mower
out from under tractor,
IMPORTANT:
1FAN ATTACHMENT OTHER THAN THE
MOWER lS TO BE MOUNTED TO THE TRACTOR, THE
R.H. AND LH. SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR,
TO INSTALL
MOWER
(See Fig. 18)
°
Raise attachment lift lever to its highest position,,
•
Slide mower undertractorwith
discharge guardto right
side of tractor,
°
Lower lift lever to its lowest position.
,,
install mower in reverse order of removal instructions°
CLUTCH ROD
RETAINER
SPRINGS
"N
CLUTCHLEVER
RETAINER
SPRING
;USPENSION
RETAINER
SPRINGS
RETAINER
SPRING
ANTI-SWAY
BAR
FIG. 18
19
Advertisement
