Assembly; Pivot Bolt 3/8-16 Unc Grade - Craftsman 944.627592 Owner's Manual

ASSEMBLY
Your new tiller has been assembled at the factory with exception of those parts left unassambled for shipping purposes. To
ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(1) Screwdriver
(1) Tire pressure gauge
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating pesitior_ (standing
behind tiller handles). -
FRONT
LEFT RIGHT
OPERATOR'S
POSITION
FIG. 1
W
(1) Handle Lock
(Black)
CONTENTS OF HARDWARE PACK
(1) Handle Lock
(Silver)
(1) Carriage Bolt
3/8-16 UNC x 1 Gr. 5
©
(1) Center Locknut
3/8-16 UNC
(1) Flat Washer 13/32 x I x 11 Ga. (1) Cable Clip
©
(1) Handle Lock Lever
(2) Hairpin Clips
(1) Pivot Bolt
3/8-16 UNC Grade 5
5