Table of Contents
Advertisement
ASSEMBLY
INSTRUCTIONS
IA WARNING I
To avoid injury, do not connect this scroll saw to the
power source until it is completely
assembled and
adjusted and you have read and understood this
instruction manual.
MOUNTING SCROLL SAW TO WORK SURFACE
(FIG. A)
1. If mounting the scroll saw to a workbench, a solid
wood bench is preferred over a plywood board to
reduce noise and vibration.
2. The hardware to mount this saw is NOT supplied with
the saw. The hardware as shown in Fig. A should be
used:
Fig, A
1
2
3
II
ii
4
6
1. (3) Hex head bolts; length as required
2. (6) Flat washers
3. Foam pad or carpet (optional)
4. (3) Lock washers
5. (3) Hex nuts
6. (3) Jam nuts
BLADE STORAGE (FIG, B)
The blade storage (1) is located on the left rear side of
the scroll saw body. Pull out the blade storage (1) to
open. The blade storage can conveniently store your
hex wrenches and both Pin-end and Plain-end blades.
Fig. B
SAWDUST COLLECTION
PORT (FIG. C)
This scroll saw will accept a hose or vacuum accessory
(not provided) to be connected to the port (1) on the
right side of base. If excessive sawdust buildup occurs
inside the base, use a wet/dry vacuum cleaner or
manually remove sawdust by removing the screws
on the right side of saw. Reattach the metal plate and
screws before starting the saw. This will keep your saw
cutting efficiently.
Fig. C
1
BLADE REMOVAL AND INSTALLATION
PLAIN-END BLADE REMOVAL AND INSTALLATION
This scroll saw accepts 5-inch plain-end or pin-end
blades to cut a wide variety of materials.
Plain-end type blades are recommended whenever
fine, accurate and intricate work is- being performed on
3/4 in. or thinner material. It will take slightly longer to
assemble the blade and blade tension, but you will also
be able to use finer blades for cutting a thinner kerf.
I A WARNING I
To avoid injury from accidental starting, always
turn the switch OFF and remove power cord plug
from power source before removing or replacing
the
blade.
Hide quick links:
Advertisement
Table of Contents
