GE Profile WPSB8060 Owner's Manual page 18

Before you call for service...
NOISE Possible Causes What To Do
Washer is noisy
Washer is uneven • To level tile ti'ont of tile washe_; a(!iust tile ti'ont leveling
legs b v rotating tile individual leg in tile proper direction
tot up or down. To level back of washe_; lilt back ot
machine 4" (l 1 cm) and set down.
Washer load is • Press START to pause the washex; open the lid and
unbalanced redistribute tile load evenl> Close tile lid and press
START again.
Shipping rod is still assembled • To remo_e shipl)ing rod fl'om washe_; pull yellow tag and
in unit attached rod fl'om tile bottom right hand side ot washe_;
Washer is sitting too close • Pull washer away fl'oln tile wall; about 4" (11 cln)
to wall (causes knocking is needed.
during cycle)
PerfeoTemp Plus feature • This is normal. PerfecTemp Plus
t/u'ns
water xalxes off
is being used and on to a(!iust water temperature.
OTHER Possible Causes What To Do
Labels on the exterior
of the washer will not
peel off cleanly
Occas'ionaJly the adhesive
used on the labels does
not release dem_ly
" Use a hair dtTer set at tile lowest heat setting, directing
the air at the label tot a short amount ot time. This will
release the adhesive easily, without damaging the surti_ce
ot the washe_:
/8