GE Profile WPSB8060 Owner's Manual page 16

Before you call for service...
PERFORMANCE (cont.) Possible Causes What To Do
Pilling
Result of normal wear on
* _qfile this is not caused b_ tile _ashe_;
}on ran slo_ the
poly-cotton blends and pilling process by washing garments inside out.
fuzzy fabrics
Snags, holes, team, rips Pins, snaps, hool¢s, sharp • Fasten snaps, hooks, buttons and zippe_.
or excessive wear buttons, belt buckles, * Remove loose items like pins, objects in pockets
zippers and sharp objects and shaq_ buttons.
left in pockets
• Turn knits (which snag easily) inside out.
Undiluted chlorine bleach * Check bleach package instructions fl)_ proper amotmt.
• Ne\vr add undiluted bleach to wash or allow clothes
to come in contact with undiluted bleach.
Chemicals _e hair bleach • Rinse items that may have chemicals on them befiwe
or dye, permaJaent wave washing.
solution
Wrinkling
Improper sorting * A\oid mi_ng
heav}
items (like _ork clothes) with
light items (like blouses).
• T U a lid)tic sottenel;
Overloading or • I,oad your washer so clothes have enough room
incorrect water level to move fl'eely.
Incorrect wash and * Match Cycle selection to tile t?])e of fitbfic you are
dry cycles washing (especially fl)* easy care loads).
Repeated washing in • \'\_lsh in wam_ or cold water.
water that is too hot
OPERATION Possible Causes What ToDo
Washer pauses in cycle The HAND WASH or CASUALS
• This is nomml. Tile washer alternates between agitate
cycle was chosen and soak during the HAND WASH and CASUALS cycles
to get your clothes cleaner with less weal:
Washer won't operate Washer is unplugged • Make sure cord is I)lugged,, securely into a working outlet.
Water supply is turned off • Turla both hot and cold timcets flfllv oil
Controls axe not set properly • Check controls.
Lid is open-safety feature • Close lid and reset cycle, to the begilming if necessary.
prevents agitation mad sphnfing
when rid is up.
Circuit breaker/fuse is • Check house circuit breakels/fllses. Replace fllses or
tripped/blown reset breaker. Washer should haxe separate outlet.
1?3ectroltics need to be reset • Uiq)lug washei; wait 2 uinmtes, plug back ill and press
START.
START was not pressed • Press START.
Extremely low water pressure • Press START again.
16