Craftsman INCREDI.PULL 316.794000 Operator's Manual page 3

• Store fuel only in containers specifically designed and approved for the
storage of such materials.
• Always stop the engine and allow it to cool before filling the fuel tank.
Never remove the fuel tank cap or add fuel when the engine is hot. Never
operate the unit without the fuel cap securely in place.
• Always mix or add fuel in a clean, well-ventilated outdoor area where
there are no sparks or flames. Do not smoke.
• Nevern Operate the unit without the fuel cap securely in place.
• Avoid creating a source of ignition for spilled fuel. Wipe up any spilled
fuel from the unit immediately before starting the unbit. Move the unit at
least 30 fett (9.1 m) from the fueling source and site before starting the
unit. Do not smoke.
• Never start or run the unit inside a closed room or building. Breathing
exhaust fumes can be fatal. Operate this unit only in a well-ventilated
outdoor area.
• Check the unit for fuel leaks.
• Loosen the fuel tank cap slowly to relieve any pressure in the tank.
• Never store the unit with fuel in the tank, inside a building where fumes
may reach an open flame (pilot lights, etc.) or sparks (switches, electrical
motors, etc.).
• To reduce fire hazard, replace a faulty muffler and spark arrestor. Keep
the engine and muffler free from grass, leaves, excessive grease or
carbon build up.
• Avoid accidental starting. Be in the starting position whenever pulling the
starter rope. The operator and unit must be in a stable position while
starting. Refer to Starting/Stopping Instructions.
• Do not touch the engine, gear housing or muffler. These parts get
extremely hot from operation, even after the unit is turned off.
• This unit has a clutch. The unit attachment remains stationary when the
engine is idling. If it does not, take the unit to a Sears or other qualified
service dealer for an adjustment.
• Turn the engine to oft and disconnect the spark plug for maintenance or
repair.
BLOWER SAFETY INSTRUCTIONS
° Stop the engine for maintenance, repair, to install or remove the blower
tubes. The unit must be stopped and the impeller no longer turning to
avoid contact with the rotating blades.
• Never point the blower in the direction of bystanders, animals, windows
or automobiles.
SAVE THESE INSTRUCTIONS
• SAFETY AND INTERNATIONAL SYMBOLS •
This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for complete
safety, assembly, operating, maintenance," and repair information.
SYMBOL
A;L
O
MEANING
• SAFETY ALERT SYMBOL
ndicates danger, warning or caution. May be used in
conjunction with other symbols or pictographs.
• READ OPERATOR'S MANUAL
WARNING: Read the operator's manual(s) and follow all
warnings and safety instructions. Failure to do so can result
in serious injury to the operator and/or bystanders.
_Jl ° WEAR EYE AND HEARING PROTECTION
WARNING: Thrown objects and loud noise can cause severe
eye injury and hearing loss. Wear eye protection meeting ANSI
Z87.1-1989 standards and ear protection when operating this
unit. Use a full face shield when needed.
"_ _ ° UNLEADED FUEL
I I
Always use clean, fresh unleaded fuel
i
• OIL
Refer to operator's manual for the proper type of oil.
___ ,, DO NOT USE E85 FUEL IN THIS UNIT
I
WARNING: It has been proven that fuel containing greater
| _ J I than 15% ethanol will likely damage this engine and void
I the warranty.
| I" c°","°"
SYMBOL
2 3
H I',1
:l®
MEANING
= PRIMER BULB
Pus h piimei bulbliu!!y and Slow!yl 0 times;
3. ° RUN choke position
Mi"i50ft(iSm) ° KEEP BYSTANDERS AWAY
I_{._ WARNING: Keep all bystanders, especially children and
pets, at least 50 feet (! 5 m) from the operating area.
• HOT SURFACE
WARNING: Do not touch a hot engine. These parts get
extremely hot from operation and may cause severe burns.
,,f',l&,._.. When the unit is turned off the engine will remain hot for a
_}_l_):_lJ)_), short time.
° BLOWERS - ROTATING IMPELLER BLADES CAN CAUSE
SEVERE INJURY
WARNING: Stop the engine and allow the impeller to stop
before opening the vacuum door, installing or changing tubes
or bag, or before cleaning or performing any maintenance.