Sharp XG-PH70X Setup Manual page 40

Stack Projection
6
Connect the INPUT 1 terminal on
the projector 1 to the RGB output
terminal on the computer using the
RGB cable.
(See page 27 on the projector operation
manual.)
7
Connect the OUTPUT (FOR INPUT
1, 2) terminal on the projector 1 to
the INPUT 1 terminal on the projec-
tor 2 using an RGB cable.
(See page 36 on the projector operation
manual.)
Note
• When connecting an RGB cable to the pro-
jector 2, use the input terminal that has
the same number as the projector 1. (IN-
PUT 1 terminal, in this case)
Application
When inputting multiple image sources, refer to the example below.
INPUT 1 terminal
Projector 1:
Master
INPUT 2 terminals
INPUT 4 terminal
INPUT 1 terminal
Projector 2:
Slave
INPUT 4 terminal
-40
RGB cable
OUTPUT (FOR INPUT 1, 2)
terminal
LAN terminal
RGB
LAN cable
cable
(cross-over
type)
LAN terminal
Composite video cable
8
Connect the LAN terminal on the
projector 1 to the LAN terminal on
the projector 2 using a commer-
cially available LAN cable (UTP
cable, Category 5, cross-over type).
9
Turn on the projectors first, then
turn on the computer.
Computer
5 BNC to 15-pin
D-sub cable
Computer
Distributor
Video equipment
Projector 1
Master
Set Inputs
INPUT1
ON
INPUT2
ON
INPUT3
OFF
INPUT4
ON
INPUT5
OFF
Projector 2
Slave
Set Inputs
INPUT1
ON
INPUT2
OFF
INPUT3
OFF
INPUT4
ON
INPUT5
OFF