Items Included; Tools Included; Tools Needed; Necessary Hardware - DeWalt DW7464 Instruction Manual

Items Included

Box #1
• (1) 52" rail system table sub-assembly
• (1) Support pan
• (1) Support bracket
• (2) Lower support rail
• (3) Rear brackets
Box #2 (Rail Carton)
• (1) Front rail sub-assembly
• (1) Rear rail
• (2) Legs
• (2) Feet
• (1) Hardware bag

Tools Included

• 6mm hex wrench
• Torx T40 wrench
• Torx T50 wrench

Tools Needed

• 17 mm open end wrench
• (2) 16mm or 5/8" open end wrench
• 13mm or 1/2" open end wrench
• Ruler
• Soft hammer or regular hammer and block of wood
• Small flat blade screwdriver
To speed assembly, the following would be helpful:
• 16mm or 5/8" socket wrench
• 13mm or 1/2" socket wrench
• T25 Torx driver

Necessary Hardware

The included hardware bags contains all the necessary
nuts, bolts, and washers to assemble the components
included with the DW7464 52" Rail System and to attach
it to the DW746 Woodworker's Table Saw. (When
attaching as an add-on accessory use new hardware in
place of removed hardware).
To make assembly of your saw/accessory easier, match
the nuts, bolts, and washers with the hardware chart.
Before each step, check your hardware against the chart
and identify the pieces you need. Additional pieces may be
included in the hardware bags.
Hardware Included with the DW7464 52" Rail System
BOLT
10 mm x 35 mm
(8 PIECES)
BOLT
10 mm x 25 mm
(5 PIECES)
CARRIAGE BOLT
8 mm x 20 mm
(11 PIECES)
10MM FLAT WASHER
(22 PIECES)
10 MM LOCK WASHER
(20 PIECES)
1
T50 TORX
FLAT HEAD SCREW
10mm X 30mm
(6 PIECES)
M 10 NUT 16 mm HEX
(13 PIECES)
M 8 NUT 13 mm HEX
(25 PIECES)
8 MM LOCK WASHER
(25 PIECES)
8MM FLAT WASHER
(19 PIECES)
M 10 JAM NUT 17 mm HEX
(6 PIECES)
6 MM HEX SOCKET
FLAT HEAD SCREW
10mm X 80mm
(2 PIECES)
CAP HEAD SCREW
8mm x 20 mm
(15 PIECES)