Included Hardware; Getting Started - JL Audio XR653-CS Owner's Manual

XR653-CS SPECIFICATIONS:
Woofers: Mineral-filled polypropylene cone body,
1-inch (25mm) voice coil, low-profile/symmetrical-
roll spider, butyl rubber surround.
Midrange Drivers: Treated pulp cone body, 1-inch
(25mm) voice coil, low-profile/
symmetrical-roll spider, butyl rubber surround.
Tweeters: 1-inch (25 mm) aluminum dome
tweeter with soft, rubber suspension,
neodymium magnet, ferrofluid cooled and
damped.Variable mounting system with
swivel/rotation capability.
Crossover Networks: 3-way network with 2nd
Order low-pass, 2nd Order bandpass and 2nd
order high-pass circuit. Premium capacitors and
inductors. 4-position adjustable tweeter output
level. Polyswitch tweeter protection.
Continuous Power Handling:
70 Watts (RMS Method)
Frequency Response: 48 Hz - 25 KHz (± 3 dB)
Efficiency @ 1W/1m: 90.5 dB
Nominal Impedance: 4 ohms
INCLUDED COMPONENTS AND PARTS:
• Two XR650-CW 6.50-inch (160 mm) woofers
• Two XR400-CM 4-inch (100 mm)
midrange drivers
• Two XR100-CT 1-inch (25 mm) tweeters
• Two XR653-CSxo 3-Way Crossover networks
2

INCLUDED HARDWARE:

• Two Flush-Mount tweeter fixtures with metal
spring clips and optional trim rings
• Two Surface-Mount tweeter fixtures
• Two 6.5-inch Metal Grilles and Grille Trays
• Two 4-inch Metal Grilles and Grille Trays
• Two 4-inch Frame Adaptors and Flush-Mount Rings
• Butyl adhesive putty for grilles
• Twenty #8 x 1 1/4-inch (30 mm) sheet
metal screws
• Sixteen #8 Mounting Clips
• Eight #6 x 1 1/4-inch (30 mm) sheet metal screws
• Four #6 x 5/8-inch (16 mm) sheet metal screws
• Eight #6 Mounting Clips
• Two 1-inch (25 mm) machine screws
• Four 6.4 mm female crimpable connectors
• Four 4.7 mm female crimpable connectors
• Four 2.8 mm male crimpable connectors
• Sixteen crimpable spade connectors
• Four black nylon wire ties
• Two tweeter extraction tools

GETTING STARTED:

• Turn off the audio system. It is also advisable to
disconnect the negative (-) terminal of your
vehicle's battery whenever performing
installation work.
• Before cutting, drilling or inserting any screw,
check clearances on both sides of the planned
mounting surface. Also check for any potential
obstacles, such as window tracks and motors,
wiring harnesses, etc. Check both sides of the car,
many cars are not symmetrical!
• Always wear protective eyewear.
JL AUDIO XR653-CS