Output Trays; Return From Copy Mode Timing - Sharp AR-M236 Key Operator's Manual

OUTPUT TRAYS

(When the printer or fax function is enabled and a JOB
SEPARATOR TRAY KIT or FINISHER is installed)
This program is used to select the respective output
trays for the copy, printer, and fax functions.
Example: When a FINISHER is installed.
* Settings that can be selected vary depending on the
options that are installed.
Settings
PATTERN 1
PATTERN 2
PATTERN 3
(When the fax
function is enabled)
PATTERN 4
(When the fax
function is enabled)
OFFSET FUNCTION SETTING
This program is used to enable or disable the offset
functions of the centre tray and offset tray (when a
FINISHER is installed).
MEMORY FOR PRINTER
This program is used to set the amount of IMC
memory that is allocated to the printer function. The
amount of memory can be set from 30% to 70% in
increments of 10%.
● Memory allocated to print hold
(When the PRINTER EXPANSION KIT is installed)
To set the amount of memory allocated to print hold,
touch the [THE MEMORY AREA FOR PRINT
HOLD] key. The amount of memory can be set from
30% to 70% in increments of 10%. If 0% is selected,
the print hold function cannot be used.
DISABLING OF CENTRE TRAY
COUNTING
This program is used to disable counting of pages
delivered to the centre tray.
When this program is enabled, centre tray full
detection does not take place.
Description
Copy: Offset tray
Printer: Centre tray
Fax: Top tray
Copy: Centre tray
Printer: Offset tray
Fax: Top tray
Copy: Centre tray
Printer: Offset tray
Fax: Centre tray
Copy: Offset tray
Printer: Centre tray
Fax: Centre tray

RETURN FROM COPY MODE TIMING

(When the printer function or fax function is enabled)
This program is used to set the amount of time that
must elapse after a copy job is finished before the
printer or fax function resumes operation. The amount
of time can be set from 1 second to 60 seconds in
increments of 1 second.
MIX SIZE ORIGINAL FEEDING MODE
(When a RSPF is installed)
When this program is enabled, originals of mixed
length (the widths must be the same) can be scanned
in copy mode and each original copied onto the
corresponding length of paper.
GENERAL PROGRAMS
13