Sharp DV-SR84RU Operation Manual page 79

PCM sampling (Default : 48kHz)
Digital Out - PCM
48kHz
96kHz
Dolby Digital conversion (Default : Stream)
Digital Out - Dolby Digital
PCM
Stream
Settings for MPEG (Default : PCM)
Digital Out - MPEG
PCM
Stream
Settings for DTS (Default : OFF)
Digital Out - DTS
ON
OFF
Changing the Setup menu
Audio setting (cont'd)
Select a setting using [Cursor K / L], then press [ENTER].
Your setting is activated.
48kHz: If your amplifier / decoder is NOT compatible with 96kHz PCM,
select "48kHz". Sound recorded at 96kHz is down sampled to
48kHz.
96kHz: If your amplifier / decoder is compatible with 96kHz PCM, select
"96kHz". Sound is sampled at 96kHz.
Note
When playing back a disc with copyright protection or virtual
surround system on this unit is set to "ON":
• Even if you select "96kHz", the sound is down sampled to 48kHz.
Select a setting using [Cursor K / L], then press [ENTER].
Your setting is activated.
PCM: Converts the Dolby Digital into PCM (2 channel).
If your amplifier / decoder is NOT compatible with Dolby
Digital, set to "PCM".
Stream: Outputs Dolby Digital signals.
If your amplifier / decoder is compatible with Dolby Digital, set
to "Stream".
Note
When playing back a DVD-RW disc recorded in VR mode:
• If the audio source on a disc is in Dolby Digital format, set "Dolby
Digital" to "PCM" so that you can switch to main audio (L), sub
audio (R), or a combination of both (L / R) using your amplifier /
decoder.
Select a setting using [Cursor K / L], then press [ENTER].
Your setting is activated.
PCM: Converts MPEG into PCM.
If your amplifier / decoder is NOT compatible with MPEG, set to
"PCM".
Stream: Outputs MPEG Audio signals.
If your amplifier / decoder is compatible with MPEG, set to
"Stream".
Select a setting using [Cursor K / L], then press [ENTER].
Your setting is activated.
ON: Outputs DTS signals.
If your amplifier / decoder is compatible with DTS, set to "ON".
OFF: No DTS signal is output.
If your amplifier / decoder is NOT compatible with DTS, set to
"OFF".
EN 79