Connecting The Power Cord; Power On And Off - Sharp AR-M200 Operation Manual

CONNECTING THE POWER CORD

Warning
1
Ensure that the power switch of
the unit is in the OFF position.
Insert the attached power cord
into the power cord socket at the
rear of the unit.
2
Plug the other end of the power cord into the nearest outlet.
Caution

POWER ON AND OFF

The power switch is located on the left side of the machine.
Power on
Turn the power switch to the "ON" position.
You can select copy settings and press the [START] key (
turned on. Copying will start automatically.
Language setting
The first time the power is turned on after shipment from the factory, a message will
appear in English in the display prompting you to select the language. Select the
language with the [
language can also be changed in the user programs (p.57).
Initial settings
The machine reverts to the initial settings when it is first turned on, when the [CLEAR
ALL] key (
time following the end of a copy job. When the machine reverts to the initial settings, all
settings and functions selected to that point are cancelled. The "AUTO CLEAR" can be
changed in the user programs. (p.54)
When in the copy mode
The main screen of
copy mode appears.
Copy ratio: 100%, Exposure: Automatic
Copy quantity: 0, All special copier modes: Off
Scanning unit (scan head)
When the machine is able to copy or scan (the ready indicator is on), the scanning unit is lit.
12
If you use the machine in a country other than the country where
the machine was purchased, you will need to make sure that your
local power supply is compatible with your model. If you plug the
machine into an incompatible power supply, irreparable damage
to the machine will result.
• Only insert the power cord into a properly grounded wall socket.
• Do not use extension cords or power strips.
The ready indicator will light up and other indicators
which show the initial settings of the display will also
light up to indicate the ready condition. For the initial
settings, see the "Initial settings" (below).
] key ( ) or [
) is pressed, or when no keys are pressed for the preset "AUTO CLEAR"
] key ( ) and then press the [OK] key. The
READY TO COPY.
100% A4 0
OK
1,2,3, ZOOM
1,2,3,
SP. FUNC
) after the power switch is