Description Of Setting Programs; Printer Settings - Sharp AR-C260 Printer Operation Manual

DESCRIPTION OF SETTING PROGRAMS

The key operator programs related to the printer function are explained here.

Printer settings

Default settings
These programs are used to adjust the settings of
various printer functions.
I I I I Prohibit notice page printing
This program is used to disable notice page printing.
Turn on this program when you do not want the
machine to print the notice page explained in "NOTICE
PAGE PRINTING" on page
I I I I Prohibit test page printing
This program is used to disable test page printing.
When the program is turned on, the PRINTER TEST
PAGE in the user settings cannot be printed. (See the
"Operation manual (for general information and copier
operation)" page 2-14.)
I I I I A4/letter size auto change
If this program is set, and printing onto 8-1/2" x 11" size
paper is selected but not available, the printer will
automatically substitute A4 size paper in place of 8-1/2"
x 11" paper if A4 paper is available.
* 8-1/2" x 11" paper cannot be automatically selected in
place of A4.
NOTE
When 8-1/2" x 11" size is specified for a document
attached to an E-mail that has been transmitted from
a foreign country and A4 size paper is not installed in
the printer, printing cannot be done without operator
intervention. If this program is set, printing will be
executed without intervention if a paper tray is
loaded with A4 paper.
TABLE OF CONTENTS
8-3.
BEGINNING OF CHAPTER
I I I I Delete the print hold data
Use this program to manually delete all stored data
from the hard disk.
When you touch this key, a message will appear to
confirm that you want to delete the data. Check the
message and then proceed with the deletion. If you are
using the job retention function
caution when using this program.
I I I I Output method when memory is full
When the internal memory becomes full with printer
data, further printing is not possible, thus the print data
stored to that point is printed. This program is used to
set the condition for printing. The factory default setting
is "1 SET".
I I I I Default paper type for bypass tray
This program is used to set the default paper type for
paper loaded in the bypass tray in printer mode.
"NONE" (a default paper type is not selected), "PLAIN",
"HEAVY PAPER", or ''TRANSPARENCY" can be
selected. If "HEAVY PAPER" is selected, select
"HEAVY PAPER 1" or "HEAVY PAPER 2". If
"TRANSPARENCY" is selected, select "SPEED
MODE" or "QUALITY MODE".
The factory default setting is "NONE".
(page 5-2), exercise
6-5