Table of Contents
Advertisement
E11
USEFUL FEATURES (Continued)
Surround sound
Produces a virtual surround sound from the TV's speakers.
Each time you press
, the mode changes
SURROUND
between ON , ON and OFF.
OFF : Produces normal sound.
ON
: Setting to this mode during stereo signal reception
produces a spacious sound, making the most of the
speakers' performance.
ON
: Setting to this mode during monaural signal reception
creates monaural sound that is similar to stereophonic
sound.
E12
CONNECTIONS
Connecting to video equipment
Enjoy playback from a video disc player, VCR or other video equipment by connecting them to
this TV set using the Audio/Video in terminals.
Example use of front terminals
Yellow : To VIDEO
White : To AUDIO (L)
Red
: To AUDIO (R)
TV
Video Game
Camcorder
To Audio/Video
out terminals
• For playback of monaural audio, connect the external source to the audio input left terminal on the front or rear of the
TV set (MONO) to hear the same sound from both speakers.
• The audiovisual cords required to connect the TV set with video equipment may differ from those shown in the above
diagram. See the operation manual of your video equipment for connection details.
• The above recording and editing connections are for intended solely for personal use and not for the illegal copying of
audiovisual material protected by copyright laws.
SURROUND
OFF
SURROUND
ON
SURROUND
ON
Example use of rear terminals
TV
For Playback
VCR
DVD Player
To Audio/
Video out
terminals
Y
To Audio/
Video out
terminals
VCR
For Recording and Editing
Yellow : To VIDEO
To Audio/
White : To AUDIO (L)
Video in
Red
: To AUDIO (R)
terminals
E13
TROUBLESHOOTING
The following problems do not always indicate a hardware failure. Therefore, please use the
TV/VIDEO
troubleshooting guide below before calling for repair service.
If, after following the guide none of the remedies work, unplug the TV set and call for service.
1
2
3
4
5
6
7
8
9
0
CH
CH
MENU
Quick
SURROUND
NORMAL
LANGUAGE
SURROUND
Service
TV
Check List
Possible Causes/Remedies
Try a new channel to check for possible station
trouble.
TV not plugged in.
Outlet power OFF.
POWER switch of TV not ON.
Antenna not connected to terminal at the back
of the TV set.
If outside antenna is used, check for broken
wires.
Check for local interference.
Y
Turn OFF using the
then turn ON again after a minute.
Adjust COLOUR control.
Check batteries in the remote control.
Try fine tuning to correct.
VCR
Contrast setting in picture mode might be all
the way to the minus side. Press the
NORMAL button on the remote control to
correct.
Increase the volume.
This unit is equipped with a microprocessor. Its performance could be adversely affected by external
electrical noise or interference. If this should happen, unplug the unit and plug it in again after a few
minutes.
POWER switch,
Advertisement
Table of Contents
