Sharp AN-PH80CW Installation Manual

INSTALLATION MANUAL
IMPORTANT NOTE TO U.S. CUSTOMERS:
The Color Wheel is backed by a 3-year parts and labor limited warranty. All service of this projector
under warranty, including Color Wheel replacement, must be obtained through a Sharp Authorized Projector
Dealer or Service Center*. For the name of the nearest Sharp Authorized Projector Dealer or Service
Center*, please call toll-free: 1-888-GO-SHARP (1-888-467-4277).
* Confi rm the name of the Dealer or Service Center referring to your projector operation manual.

Replacing the Color Wheel

Warning!
• Do not remove the color wheel from the projector
right after use. The lamp and parts around the lamp
will be very hot and may cause burns or injury.
Press STANDBY/ON on the projector
1 1
or on the remote control to put the
projector into Standby mode.
2 2 Switch the MAIN POWER switch on
the projector to "OFF" and then
disconnect the power cord.
• Unplug the power cord from the AC socket.
• Leave the lamp until it has fully cooled down
(about 1 hour).
3 3 Remove the lamp unit cover.
• Loosen the user service screw (1) that secures
the lamp unit cover. Remove the lamp unit cover
(2).
COLOR WHEEL FOR PROJECTOR
AN-PH80CW
MODEL
U.S.A. ONLY
STANDBY/ON button STANDBY/ON button
MAIN POWER switch MAIN POWER switch
AC socket AC socket
User service screw User service screw
(for lamp unit cover) (for lamp unit cover)
4 4 Loosen the 4 retaining screws from
the four-segment color wheel.
5 5 Hold the color wheel and pull it in the
direction of the arrow.
Caution
The module contains components that can be damaged
or destroyed by electrostatic discharge. Please pick the
module with the handle.
6 6 Insert the six-segment color wheel,
and tighten the 4 retaining screws.
7 7 Replace the lamp unit cover.
• Align the lamp unit cover and slide it to close (1).
Then tighten the user service screw (2) to secure
the lamp unit cover.
Info
Storing the Unused Color Wheel:
Use the zipper bag in which the six-segment color wheel was
packaged to store the unused color wheel. This bag prevents
dust and dirt from collecting on the color wheel.
Handle Handle
Printed in China
9NK5010098600
11P05-CH-NM