Table of Contents
Advertisement
Contents
Safety Precautions .................................................
Accessories ............................................................
Antenna Connection ..............................................
Location of Controls ...............................................
Basic Operation .....................................................
Language Selection .........................................
Presetting Channels ..............................................
Fine Tuning .............................................................
Flashback ...............................................................
Skipping Channels .................................................
Picture Adjustment ................................................
Accessories
After unpacking, check to make sure that the following accessories are included:
TV/VIDEO
1
2
3
4
5
6
7
8
9
0
CH
CH
FUNCTION
TIMER
PICTURE
SYSTEM
NORMAL
TV
Remote control
Antenna Connection
• The following is a brief explanation of the types of connection that are used for coaxial cables:
(1) If your outdoor antenna uses a 75-ohm coaxial cable, then
the connection to the TV is via DIN45325 plug (shown at
right). Plug this into the antenna jack at the rear of the TV
set.
(2) If your outdoor antenna uses a 300-ohm twin-lead flat
feeder, change this for a 300-ohm to 75-ohm impedance
converter and plug it into the antenna jack at the rear of
• Rod Antenna Connection
Antenna
mounting socket
Antenna jack
• Remove the power cord from the electrical outlet before connecting the antenna to the rear of the TV set.
• If you are using a rod antenna and the signal from TV station is weak or not clear, the picture may not display clearly
or properly. In this case, we recommend that you use an outdoor antenna.
Page
1
3
3
4
6
9
9
11
11
12
13
Size-AA dry batteries
Rod Antenna
Feeder
Impedance
Converter
Timers .....................................................................
Colour and Sound System ....................................
Function Adjustment ..............................................
•
•
Video Equipment Connections ..............................
Troubleshooting ......................................................
Specifications .........................................................
Rod antenna (dipole)
with ribbon feeder
300-75 impedance converter
75-ohm coaxial cable (round cable)
300-ohm twin-lead feeder
(1) Insert the rod antenna's base post into the antenna
mounting socket until it clicks into position.
(2) Connect the feeder to the impedance converter.
(3) Plug the impedance converter into the antenna jack
at the rear of the set.
Page
14
17
18
21
22
23
3
- Quick Links:
- Sound Mute
Hide quick links:
Advertisement
Table of Contents
