Dirty Video Heads - Sharp ViewcamZ VL-Z800E-S Operation Manual

Precautions

Dirty Video Heads

When the video heads have become
clogged with dirt (dust and tape coating
particles),
Striped noise
• mosaic-like noise appears on the
playback picture. (See illustrations above.)
• playback pictures do not move.
• during playback, the whole screen
becomes blue.
Causes of video head clogging
• High-temperature and high-humidity
environment
• A lot of dust in the air
• Damaged tape
• Worn tape
• Long-time use
• Dew formation
If the video heads become clogged, the
v indicator appears on the screen. Contact
the nearest SHARP service centre or your
dealer for further advice.
viii
Mosaic noise
Using a Cleaning Tape (Commer-
cially Available)
Available mode:
Tape Playback
You can clean the video head with a
commercially available cleaning tape.
Notes:
• Excessive use of the cleaning tape may
cause damage to the video heads. Please
read the instructions accompanying the
cleaning tape carefully before using it.
• The fast forward and rewind functions cannot
be used when the cleaning tape is in the
camcorder.
• If the video heads again become clogged
with dirt soon after cleaning, this might be
caused by a damaged tape. In this case,
stop using that cassette immediately.
1
Insert a cleaning tape into the
camcorder.
2
Set the camcorder to Tape Playback
mode.
• The video head cleaning screen
appears.
3
Press m on the Operation button to
begin video head cleaning.
• "NOW CLEANING" flashes during
cleaning.
S T A R T
• After about 20 seconds, video head
cleaning automatically finishes, and
"EJECT THE CASSETTE." displays.
4
Remove the cleaning tape.
To cancel cleaning, press l.
CL EA N I NG
NOW C LE AN I NG
S T O P