JVC KD-R401 Instructions Manual page 18

Category Menu items
FADER* 7, * 8
Fader
BALANCE *
8
Balance
LOUD
Loudness
VOL ADJUST
Volume adjust
L/O MODE
Line output
mode
SUB.W FREQ *
Subwoofer
cutoff frequency
SUB.W LEVEL *
Subwoofer level
BEEP
Key touch tone
TEL MUTING
Telephone
muting
AMP GAIN * 10
Amplifier gain
control
*
7 If you are using a two-speaker system, set the fader level to "00."
*
8 This adjustment will not affect the subwoofer output.
* Displayed only when "L/O MODE" is set to "SUB.W."
9
* The volume level automatically changes to "VOLUME 30" if you change to "LOW POWER" with the volume level
10
set higher than "VOLUME 30."
18
Selectable settings, [reference page]
R06 – F06 : Adjust the front and rear speaker output balance.
(Initial: 00)
L06 – R06 : Adjust the left and right speaker output balance.
(Initial: 00)
• LOUD OFF : Cancels.
• LOUD ON : Boost low and high frequencies to produce a well-balanced
sound at a low volume level.
VOL ADJ –05 : Preset the volume adjustment level of each source (except
— FM), compared to the FM volume level. The volume level
VOL ADJ +05 will automatically increase or decrease when you change the
(Initial: VOL source.
ADJ 00) • Before making an adjustment, select the source you want to
• "VOL ADJ FIX" appears on the display if "FM" is selected as
• SUB.W : Select if the REAR LINE OUT terminals are used for connecting
a subwoofer (through an external amplifier).
• REAR : Select if the REAR LINE OUT terminals are used for connecting
the speakers (through an external amplifier).
9 • LOW : Frequencies lower than 72 Hz are sent to the subwoofer.
• MID : Frequencies lower than 111 Hz are sent to the subwoofer.
• HIGH : Frequencies lower than 157 Hz are sent to the subwoofer.
9 SUB.W 00 : Adjust the subwoofer output level.
— SUB.W 08 (Initial: SUB.W 04)
• BEEP OFF : Deactivates the key touch tone.
• BEEP ON : Activates the key touch tone.
• MUTING 1/ : Select either one which mutes the sounds while using a
MUTING 2 cellular phone.
• MUTING OFF : Cancels.
• LOW POWER : VOLUME 00 – VOLUME 30 (Select if the maximum power
of each speaker is less than 50 W to prevent damaging the
speaker.)
• HIGH POWER : VOLUME 00 – VOLUME 50
adjust.
the source.