Handling The Lens Cap And Using The Hand Strap; Attaching The Shoulder Strap; Handling The Lcd Monitor Screen - Sharp VL-E71E Operation Manual

Preparation
Attaching the Lens Cap to the Hand Strap
and Fitting the Grip Strap to Your Hand
1
2
3
Open the hand strap flap and grip strap,
and slide the lens cap holder from the grip
strap as shown in the illustration below.
Pass the grip strap through the loop at the
end of the lens cap cord, and replace the
lens cap holder onto the strap.
Hold the VIEWCAM against your chest.
Then put your thumb close to the Power
Zoom buttons, pull the grip strap tight until it
fits snugly, and close the hand strap flap.
m Do not swing the VIEWCAM by its hand
1
strap.
Lens cap holder 2
Insert lens cap
holder_into hole.
Power Zoom buttons
Handling the Lens Cap
Attach here.
\
Remove the lens cap
as shown and attach it
to hand strap so it will
not get in the way
during shooting.
m Always replace the lens cap on the
VIEWCAM lens when the VIEWCAM is not in use.
1 Hold one end of the
strap and thread it
through the loop on the left side of the LCD
monitor screen.
2 Loosen the strap in the buckle, then feed
through the end of the strap, as shown.
8
3 Pull the strap in the direction of arrow.
49% 6
Repeat steps 1
other end of the
on the lens side
through 3 to attach the
shoulder strap to the ring
Left side of the monitor
I
Lens side
screen
l
Do not let anything press against the monitor
screen, and do not expose it to shock, as it may
break.
l
Do not put the VIEWCAM on a table, or any other
surface, with the monitor screen facing down.
l
Use a soft cloth to clean the monitor screen.
140