Table of Contents
Advertisement
Problems relating to images
No images appear
Have you pressed the [Power]
button?
Is the main power switch
turned off?
Are all of the indicators
switched off?
Is blank mode active?
Is a video signal being input?
Are the image signal format
settings correct?
Have the configuration menu
settings been made correctly?
Were the projector and computer
connected while their power was
already turned on?
When a computer is
connected
Moving images are not displayed
Is the computer image signal set
to output simultaneously both
externally and to the LCD
monitor?
Only when projecting images
from a laptop computer or
computer with a built-in LCD
screen
Press
on the remote control or
panel.
Turn on the main power switch at the rear of the projector.
Disconnect the power cable and then reconnect it. s page 14
Check the circuit breaker to see if power is being supplied.
Press
on the remote control to cancel the blank function.
Check that the power for the connected equipment is turned on. If
the "Message" menu command has been set to "On", messages
relating to the image signals will be displayed.
s "Settings" - "Display" - "Message" page 32
If a composite video
or S-Video
If projection does not occur when the "Video Signal" menu
command is set to "Auto", select the signal format that matches the
signal source.
s "Settings" - "Input Signal" - "Video Signal" page 33
If the signal source is connected to the [InputA] port
If projection does not occur when the "InputA" in the "Input
Signal" menu command is set to "Auto", set the signal format that
matches the signal that is being projected from the connected
equipment.
s "Settings" - "Input Signal" - "Input A" page 33
You can also press
format. s page 15
If the VCR or DVD equipment is connected using a D4 SCART
adapter
Press
to set the signal format to "D4/SCART". s page 15
When still no images appear and the DVD equipment is connected,
change the setting at the DVD equipment to RGB output.
Try resetting all of the current settings. s page 34
If the connection is made while the power is already turned on, the
function (Fn) key that switches the computer's video signal to
external output may not work. Turn the power for the computer that
is connected to the projector off and then back on again.
Set the image signal to output only externally.
s Computer documentation, under a title such as "External
output" or "Connecting an external monitor"
on the projector's control
signal is being inputÅ
on the remote control to select the
Problem Solving
37
Advertisement
Table of Contents
