JVC KD-AVX11 Installation & Connection Manual

KD-AVX11
Installation/Connection Manual
LVT1657-006A
[A]
This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does
not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.
WARNINGS
• DO NOT install any unit and wire any cable in locations where;
– it may obstruct the steering wheel and gearshift lever operations, as this may result in a traffic accident.
– it may obstruct the operation of safety devices such as air bags, as this may result in a fatal accident.
– it may obstruct visibility.
• DO NOT operate any unit while manipulating the steering wheel, as this may result in a traffic accident.
• The driver must not watch the monitor while driving.
If the driver watches the monitor while driving, it may lead to carelessness and cause an accident.
• If you need to operate the unit while driving, be sure to look around carefully.
• If the parking brake is not engaged, "Parking Brake" appears on the monitor, and no playback picture
will be shown.
– This warning appears only when the parking brake wire is connected to the parking brake system built
in the car.
Required space for installation
• You cannot install the unit on the car which has any obstacles in the space indicated below.
9.5 mm
2 mm
Control panel
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
• Make sure not to block the fan on the rear panel to maintain proper ventilation when installed.
Dashboard
Trim plate is detached on this
illustration for explanation.
* 1 When you stand the unit, be careful not
to damage the fuse on the rear.
Parts list for installation and connection
The following parts are provided for this unit. After checking them, please set them correctly.
A B C
/
Hard case/Control panel Sleeve
F G
Crimp connectors Washer (ø5)
K L
Handles Remote controller
Caution when installing
Fit the unit into the mounting sleeve by using four corners of the
trim plate.
• DO NOT press the panel (shaded in the illustration).
Do the required electrical connections.
Do not block the fan.
1
0107MNMMDWJEIN
©2007 Victor Company of Japan, Limited
D
Trim plate
H I
Lock nut (M5) Mounting bolt—
M5 x 20 mm
M N
Battery Reverse gear signal extension cord
Bend the appropriate tabs to hold the
sleeve firmly in place.
EN
E
Power cord
J
Rubber cushion