Water Filter Certifications - Dacor EF48NBSS Use And Care Manual

42 inch and 48 inch built-in refrigerators
Hide thumbs Also See for EF48NBSS:
Table of Contents

Advertisement

Ca
re a n
ea ni ng
the Water Filter
l
o not use with water that is microbiologicalty
unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
1. Locate the water filter cap in the front base grille. Rotate the
cap counterclockwise
to a vertical position and pull the cap
and filter cartridge out through the base grille.
NOTE: There will be water in the filter. Some spilling may
OCCUr.
2,
Remove the cap by sliding it off the end of the used filter. The
cap will slide to the left or right.
IMPORTANT:
Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
WATER FILTER
CERTIFICATIONS
State of California
Deparlment
of Health Services
Water
Treatment
Device
Certificate Number
03-
1551
Date Issued:
Jalmary
21,2003
'trademark/Model
Designation
Replacement
Elements
Rated
Ca_
WhMoool
WF-NLC240V
NLC240V
240 gal
Whirlpool
WF-LC4I)(IV
LC400V
400 ga]
._¢lanufaeturer:
Whtrl_ooI
Cort)
Cysts
Turblday
I no r_a ni_/Radiological
Contaminants
Organic
Contaminants
AtmZme
2.4-D
3. Take the new water filter out of its packaging and remove the
cover from the O-rings. Discard the cover.
RhteO
Semite
Fiow:
05gpm
4,
5.
Slide the cap (removed in Step 2) onto the new filter. See
illustration in Step 2.
With cap in the vertical position, push the new water filter into
the base grille until it stops. Rotate the cap clockwise to a
horizontal position. Flush the water system. See Flushing the
Water System After Replacing Filter.
Flushing the Water System After Replacing
Filter
Non-dispensing
models: Turn on the ice maker. Allow 24 hours to
produce the first batch of ice. Before using the ice, fill and discard
two full containers of ice to prepare the filter for use.
Dispensing models: Use a sturdy container to depress and hold
the water dispenser lever for 5 seconds, then release it for 5
seconds. Repeat until water begins to flow. Once water begins
to flow, continue depressing and releasing the dispenser lever
(5 seconds on, 5 seconds off) until a total of 3 gal. (12L) has
been dispensed. Additional flushing may be required in some
households.
NOTE: As air is cleared from the system, water may spurt out of
the dispenser.
Do not use where
water
is microbiologically
unsafe
or with water
of unknown
quality,
except
that
systems
certified
lbr cyst
reduction
ma 3 be used
on disin|ected
waters
that may contain
filterable
cysts.
Using the Dispenser Without
the Water Filter
You can run the dispenser without a water filter. Your water will
not be filtered.
1. Remove the water filter.
2. Slide the cap off the end of the filter.
3. With the cap in the vertical position, insert the cap into the
base grille until it stops.
IMPORTANT:
Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
4,
Rotate the cap to a horizontal position. The cap might not be
even with the base grille.
14

Advertisement

Table of Contents
loading

Table of Contents