GE Profile WPRB9220 Owner's Manual page 16

Before you call for service...
WATER(cont.) Possible Causes What ToDo
Water pumped out
Lid lifted or cycle was put in = Reset (} (le.
before cycle is complete pause for over 24 hours
Water won't drain Drain hose is ldnked or • Straighten drain hose and make sm'e washer is not
improperly connected sitting on it.
• _ 5
Top of drain outlet shoukl be less than 8 it (2.: m)
abo_e flo(m
Water spraying during
Washer in spin cycle * SAra} rinse (haJng a spin c}cle is normal.
spin cNle
Washer did not fill
Fxtremely low water pressure *
Press tile STARTpad again.
to chosenlevel
Inlet hoses are ldnked • Straighten hoses.
Water valve screens are • Turn off tile water source and disc(mnect water fill
stopped up hoses fl'om tile upper back of the _ashex; Else a brush
or toothpick to clean the screens in the machine.
Rec(mnect the hoses and turn the _ater back on.
Water fills and drains Drain stand pipe is too low • Drain stand pipe m ust be above 30" (7(5.2 cm).
at the same time
NOISE Possible Causes What ToDo
Washer is noisy
Washer is nneven = To level the fl'(mt at the washer, a(!] ust the h'ont
leveling
legs b} rotating tile individual leg in the proper direction
for up or d()x_n. To level back of _ashe_; lilt back of
machine 4" (I 1 cm)
and set d()_n.
Washer load is tmhaJa_ced • Press
STARTto
pause the _ashe_; open tile lid and
redistribute tile load evenl}. Close tile lid and press
STARTa,'_in
Shipping rod is still assembled = To remove shipping rod fl'om washe_; pull _ ellow mg and
in unit attached rod ii'om tile bottom fight hmld side of washer.
Washer is sitting too close • Pull washer a_<_? fl'om tile _<fll; flxout 4" ( 1 1 cm)
to wall (causes knocking is needed.
during cycle)
PerfecTemp
Plus feature * This is n(mnal.
PerfecTemp
Plus turns
_<xter vahes off
is being used and on to a(!iust _ater temperature.
OTHER Possible Causes What ToDo
Labels on the exterior
of the washer will net
peel eft cleanly
Occasionally the adhesive
used on the labels does
not release clem'dy
= Use a hair
(h_ er set at tile lowest
heat setting, directing
tile air at tile label for a short amount of time. This will
release tile adhesive easil), without damaging tile sm_hce
ot tile washer_
76