GE Profile WPRB9220 Owner's Manual page 15

ge.com
OPERATION (cont.) Possible Causes What ToDo
Washer won't operate START was not pressed • Press START
Extremely low water pressure • Press STARTagain.
Washer was accidentally paused • If the light on the
DELAYSTARTpad
is flashing, the
when starting Delay Start washer is paused. Press
STARYto
restmX the countdown.
WATER Possible Causes What ToDo
Toomanysuds
Type of detergent • Switch to a lower sudsing detergent brand and tollow
instructions on package.
Very soft water • T_ less detergent.
Too much detergent • Measure pmr dem_gent careflflly. Use less soap if you
have soft water; a smaller load or a lightly soiled load.
Waterleaks
Fdl hoses or dxaJn hose is • Make sure hose com_ections are
tight
at timcets
improperly com_ected and at washe_:
• Make sure eud of draiu hose is properly couuected
to washer and correctly inserted in and secured to
drain tacilitv.
Household dxaJn may • Check household plumbing. You may need to call
be clogged a I_lumbe_:
ConsmJlt water pressure to the • Tighten hoses at the timcets and turu the water off
fill hoses at the water source after each use.
• Check condition of the fill hoses; they should be
replaced eve_ T 5 vem_.
Using too much detergent • Use less detergent. Use less soap if you ha_e soft watei,
in washer a smaller load or a lightly soiled load.
Water temperature
Cooler water temperatures
• New la un(h T detergents
have been titan ulated to work
seems incorrect provide improved energy with cooler water teml)eratures .... without aflectiug, wash
efficiency pertinm a rice.
Conlrol is not set properly
• Check
water telnl)erature control and a(!just.
Water supply is turned off • Turn both hot and cold timcets hilly
on and
make sure
or improperly cmmected hoses are comaected to correct timcets.
Water valve screens axe • Turn off the water source and discom_ect l_lteI" fill
stopped up hoses fl'om the upper back of the _ashe_: Use a brush
or toothpick to clean the screens in the machine.
Recom_ect the hoses and turn the water back on.
House water heater is • Make s/u'e house water heater is delivering water
not set properly at 120°g-140°F (48°C-60°C).
Peffecremp Plus feature
• The
lid must be closed fin"
Peffecremp Plus to work.
was not activated
Wash temperature was set to
• When
the Tap Cold feature is selected, the water
TAP COLD temperature may va_ T depending on the temperature of
your household tap water:
/5