Yamaha YZFR1Y(C Owner's Manual page 70

PERIODIC MAINTENANCE AND ADJUSTMENT
1
1. Torque wrench
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kgf, 12 ft·lbf)
8. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
7
TIP
Check the washer for damage and re-
place it if necessary.
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kgf, 31 ft·lbf)
9. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 9-1.
Oil quantity:
Without oil filter cartridge replace-
ment:
3.73 L (3.94 US qt, 3.28 Imp.qt)
With oil filter cartridge replacement:
3.93 L (4.15 US qt, 3.46 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
7-15
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G Make sure that no foreign mate-
rial enters the crankcase.
1. "CD" specification
2. "ENERGY CONSERVING II"
10. Start the engine, and then let it idle
ECA11620
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
TIP
After the engine is started, the engine
oil level warning light should go off if the
oil level is sufficient.
1
2