Advertisement
IHII[II[IIIVJIJII
I
III
I
II
I
IIIIII
I
.
IIII
,m,l,Wll,_llUll
A.QQi_.]Iu[IIll
.V _t°°l
is received assembled,
repeat all steps in this'section
to be sure assembly
is correct
•,.v-...-...,,--..,
and is adjusted
for the Ol_mtor.)
iiii
IIIIIIIIII
ii
I
iiiiiiiiiiii
iiiii i
iii
IIII
i iiiiiiii
iiiiiiiii
A. PREPARATION
k
• This Operator's Manual has been developed to help you
assemble the tool and to provide its safe operation.
It is
important
that yo u read the entire manual to become
familiar with the tool before you begin assembly.
1. READ
YOUR
OPERATOR'S
MANUAL
Iltli_tlltlllI
II
IIIIIII I
Ill[
III H
IIII I mHI
i
B. ASSEMBLY
STEPS
2. Tools you Will need:
a. Small Phillips Screwdriver
b. Flathead Screwdriver
c. Needle-nose
Pliers
d. Tape Measure & Grease Pencil
e. Wrenches:
3/8 inch, 7/16 inch or
Adjustable wrench
"
ii
IlililIliilllll I I I I
I
/
1. SHIELD
_ Figure
1
A WAR mG
Failure to install the shield in the position shown in Ytgm-e
I can result in serious injury to the operator. The shield
must be centered under the b_
housing clamp with
the widest part of the shield directed toward the engine.
_
[CAI/TION:
]
The line limiter is sharp and can
Cut you.
a. Align the Stfield on the Bearing Housing with the
Shield centered under the Bearing Housing Clamp
with the widest part of the shield directed toward the
engine. Figure 1. Align screw openings.
b. Insert the four Bearing Housing Screws through the
Bearing Housing and the Shield.
c. Tighten each Screw evenly and securely with a
wrench or flathead screwdriver.
:2.TR/MMER
HEAD
-- Figure
2 &3
a. Remove the packing cover from the Arbor Shaft.
b. Place the Large Cup Washer on the Arbor Shaft. Fit
the center opening ofthe Washer around the shoulder
of the Dust Cup. Mal_ sure the Washer is against and
curved over the Dust Cup. Figure 2.
c. Threadthe TnmmerHeadclockwise
_
ontothe
Arbor Shaft.
tL4_RDWARE SHOWNACTUAL SIZE
BEARING
WIDESTPART
OFSItIELD
HOUSING
i
i
iiii
ii iii i._
d. Line up the hole in the Dust Cup with the hole in the
Bearing Housing by turning the Dust Cup. Figure 3.
e. Insert the Phillips screwdriver into the aligned holes
to keep the Arbor Shaft from turning. Figure 3.
f. Tighten the Trimmer Head against the Dust Cup
while holding the Phillips screwdriver.
g. Remove the Phillips screwdriver.
h. Press the Tap Button and pull4 inches of line from
the Trimmer Head. Figure 3. About 2 inches ofline
can be advanced each time the Tap Button is pressed.
NOTE:
To remove the Trimmer
Head,
insert
Phillips screwdriver into the aligned holes in the Dust
Cup and the Bearing Housing. Unthread the Trim-
mer Head counterclockwiseA,
m_.
Figure
3
7
Advertisement
