Adjusting The Image - Epson PowerLite 7800p Product Information Manual

If you're using OS 8.6 to 9.x:
You may need to set up your system to display on the
projector screen as well as the LCD screen. Follow these steps:
1. From the Apple menu, select
or
Monitors Monitors and Sound
2. Click the icon.
Arrange
Drag one monitor
icon on top of
the other
3. Drag one monitor icon on top of the other.
If the Arrange option isn't available, you may need to select
one of the Simulscan resolution settings:
1. Click the icon.
Monitor
Click here
2. Select a resolution as shown. (Allow a few
Simulscan
seconds for the projector to sync up after making the
selection.)
, then click
Control Panels
.
Click here
Select a
Simulscan
resolution
EPSON PowerLite 7800p Projector

Adjusting the Image

Once you see your image, you may need to make certain
adjustments.
Focusing and Zooming Your Image
Use the Focus ring on the projector to sharpen the image.
Focus ring
Use the Zoom ring on the projector to reduce or enlarge the
projected image. Move the tab toward the
bigger, or toward the
If the image still isn't large enough, you may need to move the
projector farther away from the screen. You can also use the
buttons on the remote control to zoom in on a
E-Zoom
portion of the image.
Adjusting the Height of Your Image
If the image is too low on the screen, you can raise it by
adjusting the front foot:
1. Stand behind the projector. Press the blue foot release lever
up and lift the front of the projector.
2. Once the image is positioned where you want it, release the
lever to lock the foot in position.
3. If necessary, you can fine-
tune the height by turning
the projector's rear feet.
Raising the projector may cause the image to distort or
"keystone." See the next section to correct this.
5/03 EPSON PowerLite 7800p Projector
Zoom ring
to make it
W
to make it smaller.
T
Rear projector foot
7
-