Spur And Cup/Center Installation - Craftsman 113.228000 Owner's Manual

17. Place a straightedge such as a piece of wood, metal or
framing square across the pulleys to see if they are in
line with each other, If they are, tighten the other two
motor mounting bolts. If they are not in line, loosen
the two motor bolts and move the motor sideways...
tighten the bo_ts,
18, Find four pan head wood screws 1/2" long from among
the loose parts.
Attach the belt guard plate to the bench with the two
screws. Make sure the plate is PARALLEL to the belt.
19. Plug motor cord into outlet on back of switch box. DO
NOT plug motor cord into power source outlet,
20+ Position the two cords as shown and clamp them to the
table with two cable clamps and 1/2" wood screws
from the loose parts bag.
21. Coil up the slack in the cord and tie it with apiece of
tape.
CLAMPS
MOTOR CORD
SPUR AND CUP/CENTER INSTALLATION
!. Find a 3/4-16 hex nut among the loose parts and screw
onto head stock spindle until finger tight.
3/4-16
HEX NUT
/
9