Advertisement
Assembling
the Workbench
'
Note:
For correct
assembly,
the legs, [A] and [B],
must have hinges
on the outside.
Refer to Figure
2 for steps
1 - 4
,
Attach
the foot step [C] to the leg assemblies
[A &
B] with two screws,
[D] (Me x 40), medium
washers
[El and nuts IF] (Me) on each side.
Tighten
securely.
.
Attach
the tool storage
rack [G] to the leg
assemblies
[A & B] with a screw [H] (Me x 12),
two small washers
[t], and nut [F] (Me) on each
side. Tighten
securely.
,
Attach
the rear cross bar [J] to the leg
assemblies.
Use two screws
[D] (Me x 40),
medium
washers
[E], and nuts [F'J (Me) on each
side. Tighten
securely.
4. Install foot pads [K] onto ends of each leg.
Refer to Figure
3 for steps 5 - 8
5. Place the two top supports
[L] on the front and top
Figure 2
of the leg assemblies
[A & B] with the support's
round extrusions
facing
up and away from the front
of the table. The bottom
round extrusion
holes fit
over the threaded
extrusions
of each screw arm
assembly.
.
Place the front table top [M] on the supports
[L],
aligning
the table top holes
over the round
support
moldings
and press
into place. Attach
top
using two screws
[N] (Me x 55) and two large
washers
[O]. Tighten
securely.
,
Place two table top supports
[L] on rear and top
of the leg assemblies
[A & B] with the support's
round extrusions
facing
up and toward
the front of
the table. The supports
fit into the rectangular
cut-outs
in the leg assemblies.
.
Place the rear table top [P] on the supports
ILl,
aligning
the table top holes over the support
extrusions
and press into place. Attach
top using
two screws
[N] (Me x 55) and two large washers
[O] on table top and two large washers
[O] and
two nuts [Q] (Me) on table
bottom. Tighten
securely.
Figure 3
P
,G
A
D
S
I
/
!
4
Advertisement
