Craftsman 358.794130 Instruction Manual page 4

• Do not store the unit or fuel in a
closed area where fuel vapors can
reach sparks or an open flame from
hot water heaters, electric motors or
switches, furnaces, etc.
• Store in a dry area out of reach of
children.
SAFETY NOTICE: Exposure to vibra-
tions through prolonged use of gasoline
powered hand tools could cause blood
vessel or nerve damage in the fingers,
hands, and joints of people prone to cir-
culation disorders or abnormal swelling.
Prolonged use in cold weather has been
linked to blood vessel damage in other-
wise healthy people. If symptoms occur
such as numbness, pain, loss of
strength, change in skin color or texture,
or loss of feeling in the fingers, hands, or
joints, discontinue the use of this tool
and seek medical attention. An
antivibration system does not guarantee
the avoidance of these problems. Users
who operate power tools on a continual
and regular basis must monitor closely
their physical condition and the condition
of this tool.
SPECIAL NOTICE: This unit is equip-
ped with a temperature limiting muffler
and spark arresting screen which
meets the requirements of California
Codes 4442 and 4443. All U.S. forest
land and the states of California, Ida-
ho, Maine, Minnesota, New Jersey,
Oregon, and Washington require by
law that many internal combustion en-
gines be equipped with a spark arrest-
ing screen. If you operate in a locale
where such regulations exist, you are
legally responsible for maintaining the
operating condition of these parts.
Failure to do so is a violation of the
law. Refer to the MAINTENANCE sec-
tion for information on maintenance of
the muffler and spark arresting screen.
CARTON CONTENTS
Check carton contents against the fol-
lowing list.
Model 358.794130
• Blower
• Blower tube
• 2-Cycle Engine Oil
Your blower can also be used as a
vacuum by purchasing an optional
vacuum kit (#71-79960). Contact
your Sears Service Center for de-
tails.
NOTE: It is normal for the fuel filter to
rattle in the empty fuel tank.
ASSEMBLY
_k WARNING: Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum in-
let door or attempting to insert or re-
move the vacuum tubes. The rotating
blades can cause serious injury.
_, WARNING: If you receive your
unit assembled, repeat all steps to en-
sure your unit is properly assembled
and all fasteners are secure.
BLOWER TUBE ASSEMBLY
If you have already assembled your
unit for use as a vacuum, remove the
vacuum tubes and collection bag.
1. Align the rib on the blower tube
with the groove in the blower outlet;
slide the tube into place.
NOTE: Knob must be loose enough to
allow blower tube to be inserted in blow-
er outlet. Loosen knob by turning coun-
terclockwise.
,,-"-'% Blower
_ Outlet Blower
_'_ ./ Tube
Groove _ _Rib ...........
2. Secure the tube by turning the
knob clockwise.
3. To remove the tube, turn the knob
counterclockwise to loosen the
tube; remove the tube.
-4-