Lubrication; Clean Air Filter; Inspect Muffler And Spark Arresting Screen - Craftsman C944.411420 Instruction Manual

After each use, ensure ON/STOP
switch i sintheSTOP position, then
clean a llsawdust from the guide b ar
and sprocket hole.
Tomaintain guide b ar:
• Move O N/STOP switch toSTOR
• Loosen and remove chain b rake
nuts and chain b rake. Remove bar
and chain f rom saw.
• Clean t he oilholes a nd bar g roove
after e ach 5 hours o foperation.
Remove Sawdust From ._ j_
Guide Bar G_ov_
Oil Holes o
• Burring of guide bar rails is a normal
process of rail wear. Remove these
burrs with a flat file.
• When rail top is uneven, use a flat file
to restore square edges and sides.
_('7 _ File Rail Edges_ N N
I"1
and Sides I U I
Square I I
Worn Groove Correct Groove
Replace guide bar when the groove is
worn, the guide bar is bent or cracked,
or when excess heating or burring of the
rails occurs. If replacement is necessary,
use only the guide bar specified for your
saw in the repair parts list or on the de-
cal located on the chain saw.
CHECK FUEL MIXTURE LEVEL
• See FUELING ENGINE under the OP-
ERATION section.
LUBRICATION
Bar Oil
Fill Cap
• See GUIDE BAR AND CHAIN OIL un-
der the OPERATION section.
INSPECT AND CLEAN UNIT
AND DECALS
• After each use, inspect complete unit
for loose or damaged parts. Clean
the unit and decals using a damp
cloth with a mild detergent.
• Wipe off unit with a clean dry cloth.
CHECK CHAIN BRAKE
• See CHAIN BRAKE in the OPERATION
section.
CLEAN AIR FILTER
A dirty air filter decreases the life and
performance of the engine and in-
creases fuel consumption and harmful
emissions. Always clean your air filter
after 15 tanks of fuel or 5 hours of op-
eration, whichever comes first. Clean
more frequently in dusty conditions. A
used air filter can never be completely
cleaned. It is advisable to replace your
air filter with a new one after every 50
hours of operation, or annually, which-
ever comes first. To clean filter:
1. Loosen 3 screws on cylinder cover.
2. Remove cylinder cover.
3. Remove air filter.
4. Clean the air filter using hot soapy
water. Rinse with clean cool water.
Air dry completely before reinstalling.
5. Lightly oil air filter before installing
to improve the efficiency of air filter.
Use 2-cycle engine oil or motor oil
(SAE 30). Squeeze excess oil from
filter.
6. Reinstall air filter.
7. Reinstall cylinder cover and 3
screws. Tighten securely.
,,----,,_._.._J- Cylinder Cover
Air Filter f f'_'_'///Screws
C_-_/,'_Cy,inedr er
INSPECT MUFFLER AND SPARKAR-
RESTING SCREEN
As the unit is used, carbon deposits
build up on the muffler and spark ar-
resting screen, and must be removed
to avoid creating a fire hazard or af-
fecting engine performance.
Replace the spark arresting screen if
breaks occur.
Muffler
Diffuser
Spark
Screen
Screws
\
Muffle
Body Cover
16