Craftsman 917.273644 Owner's Manual page 27

Keps Nut Hex Bolt
Terminal
Guard
Positive
(Red) Cable
Negative
'( ' (Black) Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
iNTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
o Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp automotivemtype
plugqn fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRmLL AS-
SEMBLY
1. Raise hood,
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4, When replacing hood, be sure to
reconnect the headlight wire connector,
Maintenance, repair, or replacement of
the emission control devices and systems,
which are being done at the customers ex-
pense, may be performed by any nomroad
engine repair establishment or individual,
Warranty repairs must be performed by an
authorized engine manufacturer's service
outlet,
TO ADJUST THROTTLE CONTROL
The throttle control has been preset at the
factory and adjustment should not be nec_
essary. Check adjustment as described
below before loosening cable, If adjust_
merit is necessary, proceed as follows:
1, With engine not running, move throttle
control lever from slow to choke posF
tion. Slowly move lever from choke to
fast position.
2, Check that holes "A" in governor
control lever and hole in governor plate
line_up, If holes "A" are not aligned,
loosen clamp screw and move throttle
cable until holes are aligned, Tighten
clamp screw securely,
Governor Governor
Cor_<_ _,er /Oorltro' Plate
Ho,es A' % ott,e
&o_;;_ -- Cable
Headlight Wire
Connector