Craftsman 917.273644 Owner's Manual page 22

CLEANING
o Clean engine, battery, seat, finish, etc.
of all foreign matter.
o Keep finished surfaces and wheels free
of all gasoline, oil, etc.
o Protect painted surfaces with automotive
type wax.
We do not recommend using a garden
hose or pressure washer to clean your
tractor unless the engine and transmis m
sion are covered to keep water out. Water
in engine or transmission will shorten the
useful life of your tractor. Use compressed
air or a leaf blower to remove grass,
leaves and trash from tractor and mower.
WARNmNG: TO AVOmD SERmOUS raN JURY, BEFORE PERFORMING ANY SER-
VmCE OR ADJUSTMENTS:
1. Depress clutch/brake pedal fully and set parking brake.
2. Place motion control lever in neutral (N) position.
3. Place attachment clutch in "DISENGAGED" position.
4. Turn ignition key to "STOP" and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the
right side of tractor.
1, Place attachment clutch switch in "DISm
ENGAGED" position,
2, Move attachment lift lever forward to
lower mower to its lowest position.
3, Roll belt off electric clutch pulley.
4, Disconnect anti-sway bar from chassis
bracket by removing retainer spring.
5, Disconnect suspension arms from rear
deck brackets by removing retainer
springs,
Suspension
Arms
6. Disconnect front links from deck by
removing retainer springs.
7. Raise lift lever to raise suspension
arms. Slide mower out from under trac-
tot.
iMPORTANT: If an attachment other than
the mower deck is to be mounted on the
tractor, remove the front links.
TO mNSTALL MOWER
1, Raise attachment lift lever to its highest
position,
2, Slide mower under tractor with deflec-
tot shield to right side of tractor.
3, Lower lift lever to its lowest position,
4, Connect front links to mower deck and
secure with retainer springs,
Electric
Front Link
Retainer
Spring
Anti-Sway
Bar
Retainer Springs
(Both Sides)
Shield
Retainer Spring