Advertisement
Available languages
Available languages
Add Gasoline
_
ANGER!
Never fill fuel tank indoors. Never fill
fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
_
ARNING!
Never fill fuel tank completely
full.
Provide
space for fuel expansion.
Wipe away
any fuel spillage
from engine
and equipment
before starting.
•
Use fresh,
clean unleaded
automotive
gasoline.
•
Use clean fuel and store in approved,
clean, covered
containers.
Use clean fill funnels.
Never use "stale"
gasoline
left over from last season or gasoline stored
for long periods.
•
Clean area around fuel fill cap, remove cap.
•
Slowly add "UNLEADED"
regular gasoline to fuel
tank. Use a funnel to prevent spillage.
Slowly fill tank
to about 1/2" below the bottom of the filler neck.
1/2" Air Space
Tank
Fuel
•
Before you connect your garden hose to the water
inlet, inspect the inlet screen. Clean the screen if it
contains debris or have it replaced if damaged.
Do
not run the pressure
washer
if the inlet screen
is
damaged.
•
Connect garden hose to water inlet. Tighten by hand.
•
Turn ON the water (open valve completely).
•
Squeeze
trigger on gun to purge pump system of air
and impurities.
,_
CAUTION!
Before starting the pressure washer,
be sure you are wearing adequate
eye protection.
•
Attach nozzle extension
to spray gun. Tighten by
hand.
•
Install fuel cap and wipe up any spilled gasoline.
Connect
Hose and Water
Supply to Pump
IMPORTANT:
You must assemble
wand and attach all
hoses before you start engine.
Starting engine without all
hoses connected
and water supplied will damage
pump.
•
Uncoil high pressure hose and attach one end of
hose to the base of the spray gun. Tighten by hand.
• Attach other end of high pressure hose to the high
pressure outlet on the pump. Tighten by hand.
CHECKLIST
BEFORE STARTING
ENGINE
Review the unit to ensure you have performed
all of the
following:
•
Check that oil has been added to proper level in
engine crankcase
before trying to start the pressure
washer.
•
Add proper gasoline to fuel tank.
•
Check for properly tightened
hose connections
(high
pressure
and water supply)
and for tight
connections
and that there are no kinks, cuts, or
damage to the high pressure hose.
•
Provide proper water supply (not to exceed 140°F).
•
Be sure to read "Safety Rules" and "Operation"
sections
before using the pressure washer.
Advertisement
