Table of Contents
Advertisement
POSITIVESTOP
ADJUSTMENT
SCREWFOR
45° ANGLES
L0CK
NUTlS)
Fig. 24
•
Retighten bevel lock knob. Next, retighten lock nut
securing the positive stop adjustment screw.
Recheck blade-to-table
alignment.
Note: The above procedure can be used to check
blade squareness of the saw blade to the miter
table at both 0° and 45 ° angles.
Your saw has three scale indicators, two on either
side of the bevel scale and one on the miter scale.
After squaring adjustments
have been made, it may
be necessary to loosen the indicators screws and
reset them to zero.
CU'I-rlNG
A SLOT IN THE ZERO
CLEARANCE
THROAT
PLATE
In order to use your compound miter saw, you must
cut a slot through the zero clearance throat plate to
allow for blade clearance. To cut the slot, set your
saw at 0° miter, turn saw on and allow the blade to
reach full speed, then carefully make a straight cut as
far as it will go through the throat plate. Turn your saw
off and allow the blade to come to a complete stop
before raising the saw arm.
Next, adjust the bevel angle to 45 °, turn your saw on
and allow the blade to reach full speed, then carefully
make another cut through the zero clearance throat
plate. The slot in the throat plate will then be wide
enough to allow the blade to pass through it at any
angle from 0 ° to 45".
PIVOT ADJUSTMENTS
Note: These adjustments
were made at the factory
and normally do not require readjustment.
TRAVEL
PIVOT ADJUSTMENT
The saw arm should rise completely to the up
position by itself.
if the saw arm does not raise by itself or if there is
play in the pivot joints, have saw repaired by a
qualified service technician at your nearest Sears
store or repair center to avoid risk of personal
injury.
BEVEL PIVOT ADJUSTMENT
•
Your compound miter saw should bevel easily by
loosening the bevel lock knob and tilting the saw
arm to the left.
If movement is tight or if there is play in the pivot,
have saw repaired by a qualified service techni-
cian at your nearest Sears store or repair center
to avoid risk of personal injury.
DEPTH STOP
The depth stop limits the blade's downward travel. It
allows the blade to go below the miter table enough to
maintain full cutting capacities. The depth stop
positions the blade 1/4 in. from the miter table
support.
Note: The miter table support is located inside miter
table.
The depth stop is factory set to provide maximum
cutting capacity for the 10 in. saw blade provided with
your saw. Therefore, the saw blade provided should
never need adjustments.
However, when the diameter of the blade has been
reduced due to sharpening, it may be necessary to
adjust the depth stop to provide maximum cutting
capacity. Also, when a new blade is installed, it is
necessary to check the clearance of the blade to the
miter table support before starting the saw. Make
adjustments if needed.
DEPTH
STOP
ADJUSTMENTS
See Figure 25.
•
Unplug your saw.
_11 WARNING:
Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
•
To adjust the depth stop use a 17 mm wrench or
adjustable wrench and loosen the hex nut at the
rear of the miter saw arm.
•
Use the 5 mm hex key wrench provided to adjust
the depth stop adjustment screw. The saw blade
is lowered by turning the screw counter-clockwise
and raised by turning the screw clockwise.
18
Hide quick links:
Advertisement
Table of Contents
